How does the throttle work on a car?
There is no potentiometer, electromechanical switch, or mechanical stop. The engine RPM control signal is set at idle when power is applied regardless of the control knob position. The throttle uses an Infrared Encoder (IRE) to detect the direction and speed of the control knob when it is rotated.
How do you install a remote engine throttle?
Install Remote Throttle 1. Set inner nut and star washer to allow 0.85-inch (approximately one thread) to be exposed after outer nut is tightened. 2. Install InfinityPro plate, install and tighten outer nut. 3. Slide control knob over idle button and onto outer shaft.
How do I change the model of the throttle?
2. Press the power button to ON. 3. The throttle programmed model number will show in the display. 4. Press the IDLE button on the throttle to change the model number and program it for the correct engine. 5. Press the power button to OFF and disconnect the throttle.
What kind of cable is used for Remote Throttle?
A remote throttle that is to be used with a governor as the primary controller has a short cable adjacent to the 8-pin Deutsch connector. This is the FRC datalink cable that is used to interconnect the remote throttle to the governor. The remote throttle 8-pin Deutsch connector cable is for wiring to power only..
What kind of engine throttle control do I Need?
I1994-97 Ford F-series 7.3L diesel engine electronic throttle control module for Manual Transmission use only (See Installation Instructions/Service Bulletin 99900840) PCaterpillar electronic engine throttle control for 3116E, 3126E, 3126E Version B, 3176B and 3406E engines for use on IMT SiteStar lube trucks R
Why did I switch to throttle by wire?
The main reason for the switch to TBW is that it allows the ECM to work in harmony with other engine control systems such as cruise control, traction control, torque management and stability control. Computers have taken over control of the driver’s right foot when it comes to selecting the optimum throttle opening.
How to install a throttle by wire harness?
For Installing Harness Numbers: 60221:03 –06 GM Gen III 4.8/5.3/6.0L EFI Harness – Throttle by Wire Manual P/N 90570 Painless Performance Products recommends you, the installer, read this installation manual from front to back before installing this harness. 2
How does the engine throttle work at idle?
The engine RPM control signal is set at idle when power is applied regardless of the control knob position. The throttle uses an Infrared Encoder (IRE) to detect the direction and speed of the control knob when it is rotated. The electrical signal from the encoder is interpreted by the microprocessor and the engine RPM control signal is adjusted.