How do you use Sea Foam spray?
With air filter removed, start engine and place tube nozzle into carburetor throat. Depending on engine size, use 2 to 4 ounces sprayed in bursts to avoid engine stalling. Spray a long burst, shut off engine and allow to hot soak for 10 minutes. After hot soak, start and operate engine for 10 minutes or longer.
When to use sea foam spray on engine?
Gives step-by-step instructions when applying Sea Foam Spray through the throttle body of a gasoline fuel-injection engine. This treatment will clean harmful carbon grime from critical upper engine areas including intake valves, chamber areas, pistons and rings.
Is it safe to use sea foam spray on intake valves?
Safely cleans & lubricates critical upper engine parts. Important for modern Gasoline Direct Injection (GDI) engines where fuel cleaners can’t reach the intake valves. Use Sea Foam Spray to fog intakes & spray cylinder cavities. Lubricates & protects chamber parts from dry out & corrosion.
Where is the nozzle on a sea foam sprayer?
With Hook Guide and Cleaning Tube placed in the throttle body, direct tube nozzle end ¼” in front of throttle plate location where the throttle plate opens away from nozzle (see diagram). Re-fit the intake boot over the Hook Guide and throttle body.
How do you use sea foam for fogging?
For Engine Fogging With the engine running, insert Sea Foam Spray tube (cut to shorten if needed) into intake throat (if carburetor) or directly before throttle plate opening (if fuel injection). Spray a series of 3 to 5 bursts, then a final direct stream while shutting off engine.
How to pour Seafoam into a vacuum hose?
Slowly pour Seafoam into the vacuum hose. Carefully pour one-third to one-half of the bottle directly into the detached hose. If necessary, position a funnel in the opening of the hose and pour the Seafoam in through that. The manufacturer recommends against the practice of drawing Seafoam into the hose using suction.
Gives step-by-step instructions when applying Sea Foam Spray through the throttle body of a gasoline fuel-injection engine. This treatment will clean harmful carbon grime from critical upper engine areas including intake valves, chamber areas, pistons and rings.
Safely cleans & lubricates critical upper engine parts. Important for modern Gasoline Direct Injection (GDI) engines where fuel cleaners can’t reach the intake valves. Use Sea Foam Spray to fog intakes & spray cylinder cavities. Lubricates & protects chamber parts from dry out & corrosion.
How much sea foam to add to fresh fuel?
Instructions. For high-concentration intake and upper engine cleaning and/or seasonal engine storage, mix 1 part Sea Foam to 2 parts fresh fuel in a small fuel can. Note: Less than one can of Sea Foam is providing the same cleaning ratio as adding 40 cans of Sea Foam to 10 gallons of fuel for a small fraction of the cost.