How do you unclog a pee hole on an outboard motor?
clear the pee hole Clearing the water intake is easy: trim up the motor, inspect the intake and remove any debris fouling its operation. Running through thick grass is virtually a guaranteed method to clog the water intake on your lower unit. The clog you see above is easily wiped away with your hand.
What should I do about my Suzuki outboard Pee hole?
Replaced the gear oil, motor oil and filter, water pump assembly, fuel filter, low pressure fuel filter, breather hose, thermostat, fuel assembly with hand pump, cleaned all the zincs and checked the spark plugs. All parts used are Suzuki OEM purchased at Boats.net. I’ve inspected the water pump installation 3 times and everything looks great.
How to replace the water pump impeller on a Suzuki outboard?
WHAT IS THE CORRECT PROCEDURE FOR REPLACING THE WATER PUMP IMPELLER ON A SUZUKI DT 75 OUTBOARD. NOT SURE HOW TO DISCONNECT SHIFT ROD FROM REST OF ENGINE. … read more
Can a DT 30 Suzuki outboard pump water?
Hi, I cant get my DT 30 suzuki outboard to pump water, have… I have a 2005 Yamaha 250HP 2 Stroke. Do you have a diagram I have a 2005 Yamaha 250HP 2 Stroke. Do you have a diagram on how the Hose is routed and hooked up from the Tell Tale to the Water Pump. I am … read more Is there a certain way the impeller goes on a 5.0 Mercury.
Is there a pump on my Mercury outboard?
Very good condition. Hi I have a 2001 25 hp mercury outboard. Very good condition. wasnt pumping water. replaced impeller. still not pumping water. Took thermostat out, no water being pumped to the thermostat. Help! … read more
Replaced the gear oil, motor oil and filter, water pump assembly, fuel filter, low pressure fuel filter, breather hose, thermostat, fuel assembly with hand pump, cleaned all the zincs and checked the spark plugs. All parts used are Suzuki OEM purchased at Boats.net. I’ve inspected the water pump installation 3 times and everything looks great.
How long does it take for water to come out of a Suzuki outboard?
The Suzukis like LOTS of water pressure on the muffs. And even then, it sometimes takes longer than you would expect for water to flow from the tell-tale hole. My DF115 sometimes takes 30 seconds or more for water to show.
What happens when an outboard motor impeller is broken?
The impeller is essentially a small, round disc with spinning blades used to move water through the circuit of the outboard motor. When the impeller is broken, it stops the supply of water to the engine and results in overheating.
Why is there no water coming out of the Pee hole?
The motor turns over and purrs but no water is coming out of the pee hole. I allowed the motor to run for about 5 seconds up to 15 seconds on various tries. I ran the motor without a thermostat and still no water flowing out of the pee hole. Where else should I look for a possible blockage. The only area I have not checked is the exhaust manifold.