How do you turn off the ABS light on a Honda Accord?
When the ABS indicator light goes out, release the brake pedal until the light comes on again and press on the brake pedal. Hold the pedal down until the ABS light goes out and release the pedal. The ABS light should blink twice to indicate that the code are erased.
How to reset the ABS on a Honda Accord?
4. to reset the abs ecu turn ignition off ,STEP 2 depress brake pedal,turn ignition on STEP 3,the abs light will go off after about 2 seconds. STEP 4 .after the light goes off release the pedal,the light will then come on after about 4 seconds. STEP 5 when the light comes on press the pedal again STEP.6 the light will go off again,the relase pedal.
What to do if your Honda ABS light keeps coming on?
Turn the ignition switch off, remove the key and disconnect the jumper wire from the OBD connector. If the ABS light comes back on again after step #7, do the entire procedure again, it may take a few tries to get the fault codes to clear.
How do I reset the ABS dashboard warning light on my vehicle?
At the most, you’ll need a replacement ABS sensor, a screwdriver and an OBD code reader. Note: Only do the following after you’ve already remedied the problem with your ABS system. If you take your vehicle into a shop, they should reset the light for you. But if you do maintenance yourself, you’ll have to reset the light as well.
How to fault reset Honda ABS and VSA?
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
4. to reset the abs ecu turn ignition off ,STEP 2 depress brake pedal,turn ignition on STEP 3,the abs light will go off after about 2 seconds. STEP 4 .after the light goes off release the pedal,the light will then come on after about 4 seconds. STEP 5 when the light comes on press the pedal again STEP.6 the light will go off again,the relase pedal.
Turn the ignition switch off, remove the key and disconnect the jumper wire from the OBD connector. If the ABS light comes back on again after step #7, do the entire procedure again, it may take a few tries to get the fault codes to clear.
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
How can I get my Honda dash lights to stay on?
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do.