How do you turn off an inertia switch?
The inertia switch was reset by simply pushing the red button on the switch. The switch could also be manually pushed to turn off the fuel pump, which worked nice for turning off the fuel pump when servicing the fuel system. Like it or hate it, Fords Inertia switch was still a great safety feature.
Where is the emergency fuel shut off switch?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Is the inertia switch supposed to be up or down?
The inertia switch is a safety item incorporated by Ford in the fuel system of its vehicles. The only time the inertia switch should trip is during a collision. With the inertia switch in the open position, the red button is raised up. It is not supplying power to the fuel pump in this position.
Why does my Toyota Sequoia wear out so fast?
Toyota addressed this issue by having its dealers either apply more lubricant to the switch or replace the switch circuit board for free. Premature Front Lower Ball Joint Wear: The front lower ball joint in some first-generation Sequoia SUVs contains internal lubricant that deteriorates faster than expected.
What causes a Toyota Sequoia switch to melt?
This allows debris and moisture to get in and cause the switch to short circuit and melt. Toyota addressed this issue by having its dealers either apply more lubricant to the switch or replace the switch circuit board for free.
What causes premature ball joint wear on Toyota Sequoia?
Toyota addressed this issue by having its dealers either apply more lubricant to the switch or replace the switch circuit board for free. Premature Front Lower Ball Joint Wear: The front lower ball joint in some first-generation Sequoia SUVs contains internal lubricant that deteriorates faster than expected. That leads to premature ball joint wear.
How do you remove the inertia switch on a car?
Remove the inertia switch cover by either prying the plastic clips loose or removing the screws that hold it in place. Inside the switch you’ll see one of three things: a button, a circuit-breaker-type switch or a fuse. Push the button or flip the breaker switch back to its original position.