How do you take the door off a Mercedes A Class?
SUPPORTER
- Remove the mirror cover.
- Remove the access cover.
- Remove the back of the pull recess.
- Unscrew two T30 bolts.
- Remove the retaining clip on the side of the door.
- Unclip 8 (or 11 for a coupé version) clips.
- Lift the card up carefully, until the door pin is free.
- Disconnect the windows switch and the courtesy light plugs.
How do you remove the door panel on a Mercedes C class?
Figure 4. Lift the door panel up and pull it outward. Near the center of the inside door panel is the door lock cable. Pull it up from the actuator latch to free it from the door panel. There is a small connector behind the door panel speaker. Insert a plastic pick into the empty slot of the connector to un-clip the latch.
When did Mercedes Benz a class doors need to be replaced?
Lofty’s Homepage, Mercedes-Benz ‘A’ Class, Components, undertaking repairs to door locks , removing inner door panels, removing component parts, replacing locks, special torx tool reqd. Component parts and Assembly Removal of Inner Rear Door Panel 1/3/2001 onwards Replacing defective locking mechanism Replacing Defective Door Hinges,
How to remove inner door from Bert Rowe’s Mercedes?
When returning this position it carefully and apply pressure , it will snap back into place. Having removed the cover, remove the two screws using the T30 ‘Torx’ bit. Now using the wedges unclip the main inner door panel.
How to unclip a door lock on a Mercedes?
The door lock plunger Ccan be unclipped. The Electric window switch cable Acan be easily disconnected using a fine blade screw driver to lift the bar on the switch, this done you can then work on the other components. I had an assistant which saved me the job of unclipping the locking mechanism fully.
Do you need to remove door panel on Mercedes-Benz E-class?
The ride quality of your Mercedes-Benz E-Class is already considered the best in its class by enthusiasts and critics alike. Although it may seem as if nothing more can be done to enhance your w212, there is always the audio system. To start an upgrade of the front speakers, you must remove the door panel.
How to remove door trim on Mercedes W212?
Open the door and use a trim removal tool to pry out the armrest cover. Remove the two Hex screws with your T27 Torx screwdriver. Use the trim removal tool to pry out and loosen the A-pillar tweeter housing. The trim can then be gently removed by hand. Figure 1. Remove the door panel covers.
Where is the door lock on a Mercedes W169?
I am stuck trying to remove the door lock barrel from the inner mounted door module on the driver’s side front door of my Mercedes Benz 2007 A-class W169. I have undone the Torx T15 screw from the door outer edge, and the Torx T15 screw seen from the small hole in the door frame which is on the rear of the barrel lock.
Can you remove the door card on a 2005 W169?
The barrel is loose but will not come out, and until this is removed I can not remove the door module. We had the same problem on a late 2005 W169. Note you do not need to remove the door card if you just want to remove the door lock cylinder and exterior handle.