How do you reset the TPMS on a Pontiac Torrent?
With DIC Button
- Press and hold the ✓ button until the horn sounds twice.
- Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds.
- A horn chirp will confirm that the sensor has been reset.
How does the TPMS work on a Pontiac Torrent?
Your vehicle was equipped from the factory with a tire pressure monitoring system (TPMS) that turns on every time you start the engine. When new tire pressure sensors are installed, they must be registered to the vehicle using a sensor triggering tool. 1.
How to reset GMC TPMS tire pressure monitoring system?
Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR. The horn will chirp, after the vehicle has received a signal from each sensor. After activating the LR tire, the horn will chirp twice signifying the relearn is complete. Turn the ignition to the OFF position.
What happens if you turn off the TPMS?
You can now turn the vehicle off. If there is a problem with the TPMS, “SERVICE TIRE MONITOR” will display on the DIC and the tire pressure indicator will flash for approximately one minute then stay lit. If you see one of these warnings, the system is off and is not monitoring the tire pressures.
How to register a new tire pressure sensor?
When new tire pressure sensors are installed, they must be registered to the vehicle using a sensor triggering tool. 1. Make sure all tires are inflated to the vehicle’s recommended inflation pressures (found in the owner’s manual on the door placard) 2. Turn the ignition key to the ACCESSORY position and apply the parking brake.
Your vehicle was equipped from the factory with a tire pressure monitoring system (TPMS) that turns on every time you start the engine. When new tire pressure sensors are installed, they must be registered to the vehicle using a sensor triggering tool. 1.
How to fix a low tire pressure light?
Next step in the process is to press the located button for three seconds. Once the light blinks for three times on the dashboard, this means the TPMS is reset. After this, turn off the engine and again start it after five seconds (from the time, light blinks). This would resolve the issue.
How to reset a stuck low pressure ( TPMS ) light?
Put the key in the ignition and turn it to the “on” position, but do not start the car. Press and hold down the reset button (sometimes located under the steering wheel) until the low-pressure light blinks three times. Release the button. Start the vehicle and let it run for 20 minutes to let its computer re-calibrate each sensor.
Where is the tire pressure light located on a car?
As discussed earlier, the TPMS is located on the rim of the tire. Thus, there are chances that this electronic box gets damage during the tire change process. So, whenever you are going for a car’s tire change, do check the pressure light there and then.