How do you reset the tire pressure light on a 2020 Hyundai Santa Fe?
To reset the low tire pressure light on the Hyundai Santa Fe, press and hold down the TPMS Reset button until you see the light blink 3 times, then start the car and leave it on for 20 minutes.
What should the tire pressure be on a Hyundai Santa Fe?
33 PSI
Hyundai Santa Fe Tire Pressure: 33 PSI.
What to do if your Hyundai Santa Fe has low tire pressure?
• When there is a malfunction with the TPMS. In this case, have your vehicle inspected by an authorized HYUNDAI dealer as soon as possible. For more details, refer to “Tire Pressure Monitoring System (TPMS)” in chapter 6.
Why does my TPMS not work on my Hyundai Santa Fe?
TPMS malfunctions may occur for a variety of reasons, including the installation of replacement or alternate tires or wheels on the vehicle that prevent the TPMS from functioning properly.
Why is my tire pressure sensor warning light on?
Disturbed or Tripped Sensor. If you’ve recently had your vehicle serviced and the tire warning light activated immediately or shortly after, it’s likely that something tripped one or more of the tire pressure sensors. Some models require the TPMS to be reset after adding pressure.
What does it mean when your TPMS warning light is on?
So check your tires carefully. If your vehicle has a TPMS, it’s probably monitoring the pressure in your spare tire. Therefore, if you get a low tire pressure warning light, and if you’ve checked all four tires that are touching the ground, than you might need to put some air in the spare.
• When there is a malfunction with the TPMS. In this case, have your vehicle inspected by an authorized HYUNDAI dealer as soon as possible. For more details, refer to “Tire Pressure Monitoring System (TPMS)” in chapter 6.
How does the TPMS work on a Hyundai Santa Fe?
1) Condition – Ignition ON and Engine OFF. 2) Hold the TPMS module within 3 inches (76 mm) of the sensor valve, read each tire pressure sensor ID in the following order: front left, front right, rear left, then rear right. 3) Press the ENTER button as each tire is illuminated on the screen.
When does the low tire pressure warning light go off?
Once you set the ignition switch or Engine Start/Stop Button to the ON position. – It illuminates for approximately 3 seconds and then goes off. When one or more of your tires are significantly underinflated (The location of the underinflated tires are displayed on the LCD display).
So check your tires carefully. If your vehicle has a TPMS, it’s probably monitoring the pressure in your spare tire. Therefore, if you get a low tire pressure warning light, and if you’ve checked all four tires that are touching the ground, than you might need to put some air in the spare.