How do you reset the service message on a Volvo xc60?

How do you reset the service message on a Volvo xc60?

How To Reset A Volvo Service Light

1. Put your key in the ignition and turn it to position one.
2. Next, turn your trip computer to trip one.
3. Press and hold the trip computer while turning your key to position two.
4. The center arrow will flash red three times.

How do I reset my service xc60?

With Turn Signal Lever

1. Press and hold the OK button on the end of the lever while holding the START/STOP ENGINE button.
2. Keep holding the OK button until the ⓘ indicator blinks.
3. Release both buttons when you hear a chime.
4. Verify the indicator has been reset by starting the engine.

How do you reset the maintenance light on a 2015 Volvo XC60?

Press and hold the OK/Reset button on the left steering wheel stalk. Switch the ignition to position II while still holding the OK/Reset button. Wait 10 seconds while still holding the OK/Reset button. Release the OK/Reset button when the information light starts to blink.

How do I reset my Volvo on Call?

For Volvos with the SPA Sensus Connect System:

1. Tap the tab on the upper edge of the display (you will see Settings or Owner’s Manual)
2. Select Settings.
3. Select System.
4. Select Global Reset.
5. Select Factory Reset.
6. Select OK.

Where can I get service on my Volvo S60?

You can call Volvo directly at 800-458-1552 or NHTSA at 888-327-4236. Reference TSB No. TJ30021. Need to find a dealer for service? Go to Cars.com Service & Repair to find a local dealer. Editor’s note: This is only one of dozens of service bulletins issued each month by automakers.

How to reset book time for maintenance Volvo S60?

How to reset book time for maintenance warning light on a Volvo S60 second generation. Made between 2010, 2011, 2012, 2013, 2014, 2015. To turn off this service required message you must follow next procedure. With ignition to off position.

When to aborted engine service on Volvo V40?

This is not usually a big problem between annual services, but the regeneration process is intended to take place during 20-30 minute periods constant high-speed driving. If you drive mostly short trips around town the regeneration cycle will not complete and so will be aborted and attempted again at some time later.

How does the engine management system work on a Volvo?

When it detects the DPF needs to be regenerated, (burning off the soot trapped by the filter), the engine management system injects diesel into the exhaust stroke of each cylinder. This burns in the hot exhaust gas, raising temperature of the exhaust to that required for the regeneration process.