How do you reset the oil light on a Ford Fuso?
Re: how to reset oil light on Mitsubishi fuso fe160 ? Most lights are reset by turning the key on, press the fuel/gas pedal three times within five seconds, slowly. Wait for the flashing to stop.
Can I use 10W 40 instead of 15W40?
A 10W40 oil will be thicker in the cold than 15W40 oil, but they will have the same viscosities at higher temperatures. Hence, a car will start with fewer cranks when holding oil of a lower winter weight. 10W40 oil will perform cold starts better than 15W40 oil.
How to reset oil light on Mitsubishi Fuso fe160?
1. Turn the starter switch to “ON”. Do not start the engine. 2. Depress the accelerator pedal to the floor and keep it there for at least 20 seconds. 3. While still keeping the accelerator pedal depressed to the floor, pump the brake pedal at least 6 times.
How to reset the service interval ( oil change ) light?
How to Reset the Service Interval (Oil Change) Light with MaxxForce Engines 1 Set park brake 2 Turn the key on 3 Turn the cruise on 4 Turn the cruise off 5 Turn the cruise on 6 Very rapidly push the resume switch four times and then hold down on the fifth time for four seconds. 7 The “Change Oil” message should clear from the odometer window.
What happens when you restart a Mitsubishi Fuso?
Restart the engine after waiting about 10 seconds. Restarting the engine may reset the computer program and the system may start working normally in some cases, but this may not take place in other cases. contact an authorized MITSUBISHI FUSO distributor or dealer.
Why does my Fuso have engine system light flashing?
Response time will vary depending on my work load , etc. The lights flashing mean there are fault codes logged that indicate what circuit the problem is in to know where to start troubleshooting. Let me know what you have for fault codes logged in the ECM and also the complete engine model number from the engine ID tag.
https://www.youtube.com/watch?v=l_YpLel8kNY