How do you reset the maintenance required light on a 2006 Scion xA?
Scion xA Maint Reqd Light
- Turn the key to the on position with the odometer showing.
- Press and hold the odometer button.
- Turn the key to the off position while still holding the odometer button.
- Without releasing the odometer button, turn the key to the run position.
- Wait a few seconds for the light to turn off.
How do you clear the maintenance required light on a Scion xA?
Hold down the trip meter reset button and turn the ignition on. Keep the button pushed in. The maintenance required light will flash for a few seconds. when it turns off, let go of the reset button.
What does it mean when the maintenance required light comes on?
The maintenance required light is notifying you that maintenance is required according to the driven distance on the vehicle’s maintenance schedule. Most often this just means your vehicle might be due for an oil change.
How do you reset the check engine light on a 2009 Scion tC?
to turn it off set your odo/trip to odo mode, turn off the engine hold the reset button down, then turn on there car still holding the reset down until the car is fully on then it should just shut right off.
How do you clear the codes on a Scion XB?
Turn the key to the “off” position. Press down and hold the odometer switch. Do not release it until instructed. Turn the key to the “on” position without starting the engine while keeping the odometer switch depressed.
How to reset maintenance required light in a Toyota?
Reset the maintenance required light in a Toyota after you change your oil so you know when to do your next oil change. This process works on most Toyotas including Camry, Tacoma, Corolla, Avalon, Tundra, Sienna, Rav4, 4Runner, and many more. Step 2: Hold down the “reset trip” button and shut the car off.
Where is the maintenance light on a Toyota Camry?
You will find the maintenance required light on the dashboard of the Toyota Camry. Labeled as MAINT REQD, the light reminds the driver about the due time of an oil change. Remember that the indicator does not have any connection to any sensor or signal any internal malfunction and failure of components.
How long does it take to reset a Toyota Corolla Minder light?
Time needed: 7 minutes. When engine oil needs to replace, the MAINT REQD message will appear on the display. The engine oil maintenance data must be reset after performed the maintenance service or change the engine oil on your vehicle.
How to reset the maintenance light on a 2006 Scion xB?
Press the odometer toggle stem until the total mileage is displayed (not the “trip” mileage). Turn the key to the “Off” position. Press and hold the odometer stem. Turn the key to “On” without starting the engine. Hold the odometer stem until the display shows “000000.” Turn the key to “Off” then turn it back on.