How do you reset the computer on a 2002 Ford Explorer?
- Enter SYSTEM CHECK to display. “OIL XXX% RESET IF NEW”.
- Press SELECT/RESET control. switch to display “HOLD RESET IF. NEW OIL”.
- Press and hold the.
How do I reset my Ford Explorer computer?
How to Reset a Ford Explorer Computer
- Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board.
- Disconnect the negative battery terminal.
- Wrap the negative clamp in a towel.
- Leave the negative battery cable off for a minimum of five minutes.
Is the 2002 Ford Explorer XLT 4 wheel drive?
2002 Ford Explorer XLT does not engage in 4 wheel drive. Disconnected negative terminal to battery, removed 4X4 Control Module, inspected module, modulel looks new, reconnected 4X4CM and reconnected negative cleaned battery terminal. 4 wheel drive still will not engage in nuteral or drive. Should we take it to Tunex?
Where is the electric shift motor on a Ford Explorer XLT?
The electric shift motor is mounted externally at the rear of the transfer case. It drives a rotary cam which moves the mode fork and range fork within the transfer case between the HIGH range (A4WD, 4HIGH) and LOW range positions.
How does Ford Explorer disengage from low range?
To engage or disengage LOW range, the vehicle speed must be less than 5 km/h, the brake depressed, and the transmission must be in NEUTRAL. The front/rear driveshaft speed sensors (Hall effect) are mounted to the transfer case and detect the speed of the front and rear driveshafts.
Where are the digital sensors on a Ford Explorer XLT?
The shift motor sense plate, an integral part of the electric shift motor, informs the GEM to the position of the transfer case. The digital TR sensors are located on the LH side of the transmission; these sensors inform the GEM when the transmission is in the neutral position.
https://www.youtube.com/watch?v=Rg0dC27gsaI