How do you reset the check engine light on a 2004 Volkswagen Passat?
How to Reset Your VW Check Engine Light
- Turn off the ignition, and then put on safety glasses and gloves.
- Pop open the hood and locate the negative terminal on your battery.
- Loosen the nut on the negative terminal with a wrench, then pull the negative connector from the battery.
How do you turn off the check engine light on a VW Passat?
How to Reset Your VW Service Light by Model Year
- Turn your key into the on position.
- Select the Settings menu.
- Select the Service submenu.
- Select Reset option.
- Press OK.
- Press OK again to confirm.
How do you clear a VW code?
How to Reset a Volkswagen Check Engine Light
- Connect the diagnostic code scanner to the vehicle’s diagnostic port.
- Turn the key to the “Run” position, but do not start the engine.
- Press the button on the scanner that reads “Scan for trouble codes.”
- Wait for the scanner to finish scanning the engine’s computer.
How do you reset the check engine light on a 2008 Volkswagen Passat?
Press the Min clock button and then release the wrench button. With key off press and hold the 0.0 button on the cluster. With your other hand turn the key to the on position , while still holding 0.0 button, press the minute button for 1 second and you will see the service reset.
What does a check engine light look like on a Volkswagen Passat?
While the color and location of the Check Engine Light will vary by vehicle, in the majority of cases it is a dashboard warning light that is yellow and shaped like an engine. This indicator is part of the onboard diagnostics (OBD-II) system.
How do you reset a service engine light?
Using a socket, remove the single bolt holding the terminal in place. Remove the terminal from the battery stud. Ensure that the terminal no longer makes contact with the stud. Wait 15 minutes, then replace the terminal on the stud and tighten the bolt using the socket set.
What to do if your engine light comes on after changing spark plugs?
Or you might have left a wire harness unplugged somewhere. check all harness connections that you touched during the install. also, get a code reader or have autozone or some other parts store pull codes for you to see why the light is on. otherwise, take it to your dealer and they’ll take care of it. You could reset it and see if it comes back on.
How can I get my Check Engine light back on?
Check your repair manual to find the fuse to the engine control unit. Once you have your check light disappear, using any of the five above-mentioned methods, then you are ready to go.
How to reset service engine soon light Paul’s gigantic?
Place your foot on the accelerator and press it in, but this time, do not release, hold it there for ten seconds. During this step, the SES light will start to flash. 5. Release the Accelerator Release the accelerator pedal after the 10 seconds and see the engine light still blinking. 6. Turn OFF the Ignition