How do you reset the blend door actuator?
Remove the floor air outlet duct extension (1) from the floor duct (2). Disconnect the electrical connection at the blend door actuator (#10 in pic below). Remove the blend door actuator mounting screws from the HVAC module. Remove the blend door actuator as an assembly with the actuator cam.
Why is my Blend door not calibrated properly?
The Dealer calibrated the blend doors but the problem still came back. I think the blend door motor is not regulating across the temperature range. I had a broken blend door gear and the dealer replaced the gear and the blend gear motor.
Why is my Jeep Grand Cherokee blend door not working?
I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014. The heating is working on high only and I can’t adjust the temperature. The Dealer calibrated the blend doors but the problem still came back. I think the blend door motor is not regulating across the temperature range.
What’s the difference between old and new blend door motor?
The old blend door motor had a black shaft where the gear is mounted and the new motor, which the dealer installed has a white shaft, where the gear is mounted. Can anybody help me in solving the issue? I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014.
How to calibrate the blend door actuator motor?
Blend Door Actuator Motor Calibration 1 15 in the fuse box next to the battery. 2 Remove the fuse and wait 1-2 minutes for any capacitive charges in the system to dissipate. 3 Replace the fuse. 4 Turn the ignition key to the on position. You can now watch the motors move as the system goes through the calibration routine.
The Dealer calibrated the blend doors but the problem still came back. I think the blend door motor is not regulating across the temperature range. I had a broken blend door gear and the dealer replaced the gear and the blend gear motor.
I have a problem with the blend door motor on the driver side in my Jeep Grand Cherokee 2014. The heating is working on high only and I can’t adjust the temperature. The Dealer calibrated the blend doors but the problem still came back. I think the blend door motor is not regulating across the temperature range.
Where is the fuse on a blend door actuator?
Open hood (bonnet for the RHD guys) and locate fuse #15 in the fuse box next to the battery. Remove the fuse and wait 1-2 minutes for any capacitive charges in the system to dissipate. Replace the fuse. Turn the ignition key to the on position. You can now watch the motors move as the system goes through the calibration routine.