How do you reset the anti theft system on a 1997 Pontiac?

How do I reset the theft system on a 1997 pontiac sunfire.

Turn ON the ignition, with the engine OFF.
Attempt to start the engine, then release the key to ON.
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.
Turn OFF the ignition, and wait 5 seconds.

How can I bypass pass theft-deterrent system?

The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel.

When does the anti theft system car wont start?

If the engine does not respond or dies immediately after cranking up, leave the key in that position for 10 minutes. When the security light goes off, turn the ignition off, wait 20 seconds, and then start the engine. These are the most popular ways to solve the problem of anti theft system car wont start.

How do you reset the anti theft system?

Insert the key into the door lock, on the driver’s side door. Turn it on, but don’t turn it back. Instead, hold the position for 40-60 seconds. This indicates to the system that you have the right key. Also, do the same by turning the key in the opposite direction and holding the position.

How do you reset the anti theft system for a 1997 Cadillac?

Verify that the correct key code (key pellet) is being used to start the vehicle. Using J 35628-A, measure each key pellet for the vehicle, all the key codes should match. Wait approximately 3 minutes for the system disable timer to expire, attempt to restart the engine using a known good key with the correct key code.

How to reset the anti-theft light on your truck?

Truck won’t start when anti-theft light is blinking. How do I reset it? Is this a good question? 1, Try turning the key and moving the shift from park to drive and back. Then try starting it again! 2. Try your spare key in case the chip has failed in your primary key. 3.

How do you reset the anti-theft system on a 1997 Pontiac?

How do I reset the theft system on a 1997 pontiac sunfire.

Turn ON the ignition, with the engine OFF.
Attempt to start the engine, then release the key to ON.
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.
Turn OFF the ignition, and wait 5 seconds.

How do I reset my old alarm system?

You can reset your alarm system by powering it down and then powering it back on. This is what is known as a power reset. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. Then reconnect the battery and transformer to power it back on.

How do I bypass the security system on a 1997 Nissan Pathfinder?

If you see it and your sure it doesn’t belong to anything else, try holding it down for about 5-10 seconds and with the button still pressed, try starting the car. If it starts, turn it off again and if the little red car alarm led on your dash or door stays off, then the alarm should be disabled.

How do I bypass GM PassLock?

How to Disable a GM PassLock System

Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
Look at the dashboard and locate the theft system light.
Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do you bypass the anti theft system on a 1999 Pontiac Sunfire?

How do you bypass the anti theft system on a Pontiac Sunfire? Press and hold the “Valet/ Override ” button located under the dash. Hold the button until the blinking LED light on your dash is solid. Switch your “Valet” button to “Off” if you have a button labeled “On/Off.” Your alarm should now be reset.

How do I reset my home alarm without the code?

How to reset a house alarm without a code or you’ve lost it?

Go to your alarm system’s main access panel.
Remove the power plug to the alarm console from the socket.
Unlock and open the main panel with the console access key, or a small tool, such as a screw.
Disconnect one of the wires from the system’s main battery.

How do you reset the security system on a 2007 Nissan Pathfinder?

Exit the car with all doors closed and the windows rolled up. Also close and any rear doors such as the trunk, rear hatch and front hood. Lock the car using the drivers side lock and walk away from the car at least ten feet. Wait for fifteen minutes and unlock the door, this should reset the security system.

How to reset the security system on a Honda Accord?

The alarm should now be disabled. Start your Honda Accord’s engine and allow the vehicle to run for at least 10 minutes. This will allow the Accord to reset the alarm. When you’re done, you can shut off the Accord and arm the system as usual. The links may also help. Good luck.

When to turn off the anti theft system?

When you are inside the car. Apply this trick when you have access to the car’s interior and the ‘Theft System’ light on the dashboard is ON. Insert the key in the ignition slot and turn it to the right only slightly. Keep it in that position for 10 minutes or a little more. It is likely to turn off the light and start the car.

How to unlock the Chrysler anti theft system?

If you repeat the starting procedure with the wrong key, the system will disengage the starter on the 7th attempt. The only way to unlock the system at that point is to use the proper key, or have the system reprogrammed with a factory scan tool or by doing a customer learn procedure.

What happens when you deactivate your anti lock system?

Keep in mind that if you deactivate your anti-lock system for a long or short while, your car will no longer generate warning signs at the first indication of a possible break-in. Your alarm will not sound and your horn and emergency flashers will not come on. Also, flashing lights will not appear on your dashboard.

Navigation