How do you reset an electric dog collar?
Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.
How do you sync a pet safe shock collar?
Press the button on an angle to see the upper half of the button while holding. Press and hold the upper left button on the remote to pair the collar. The collar will flash five times and then begin beeping to confirm it is paired. Release the button and test to confirm it is properly paired.
Why is my shock collar not working?
Check that the battery on the receiver collar is fully charged and replace it as needed. Next, confirm that the transmitter and collar are properly synced. Then check that you haven’t set the correction level so low that it isn’t responding. Lastly, check the fit of the collar on your dog.
How do I turn on my Innotek shock collar?
To turn the Receiver ON or OFF, hold the Receiver within one inch of the Transmitter antenna as shown in the Quick Start Guide. Be careful, do not touch the metal contacts that touch your dog’s skin. Press the Tone/ ON/OFF button.
How do I reset my pet safe collar?
Make sure the collar is powered on. Press and hold the button on the collar until a beep is heard and the light flashes green to turn the collar on. Press and hold the power button for 10 seconds to reset the collar.
How do you test a dog shock collar?
Touch both points on the collar while it is ticking or beeping. If you do not feel a shock, then there may be a problem with the receiver collar. Make sure you touch both points on the receiver at the same time when you hear the collar beeping.
What collars work with Innotek?
The Innotek UltraSmart Extra Fencing Collar (model IUC-4225) is compatible with the Innotek IUC-4100/4200/5200 containment systems. The SlimLine Innotek extra collar offers a unique Fit Test feature to help you properly fit the collar to your dog.
How do I change the battery in my Innotek dog collar?
Twist the battery cover, located on the back of the receiver box between the two contact probes, counter clockwise. Remove the cap and set it aside. Tilt the receiver box until the two batteries fall out. Replace them with two new 3-volt lithium coin cell batteries.