How do you replace the thermostat on a Jeep Cherokee?
4. Bolt the thermostat housing back on. I would recommend starting with the top bolt, leaving it loose, and then the bottom bolt. Tighten both bolts evenly, and don’t over tighten them. 5. Reconnect the heater core hose and the radiator hose, and clamp them down. 6. Allow RTV to dry for the recommended time.
What should the temp be in a Jeep Cherokee?
Make sure not to mix coolants as red and green coolant don’t mix well and can end up becoming a jelly like substance. The last step is to start your Jeep up and let it idle. The temperature gauge should climb to 160*, 180*, or 195* depending on what thermostat you just installed.
How do you remove a thermostat from a cylinder head?
Remove the two, 1/2 inch bolts holding the thermostat housing on. The top one is much longer than the bottom one. The serpentine belt might be in the way of the lower bolt. If the belt is in the way, just loosen the tensioner and push the belt out of the way. 4. Remove the thermostat housing from the cylinder head.
4. Bolt the thermostat housing back on. I would recommend starting with the top bolt, leaving it loose, and then the bottom bolt. Tighten both bolts evenly, and don’t over tighten them. 5. Reconnect the heater core hose and the radiator hose, and clamp them down. 6. Allow RTV to dry for the recommended time.
Make sure not to mix coolants as red and green coolant don’t mix well and can end up becoming a jelly like substance. The last step is to start your Jeep up and let it idle. The temperature gauge should climb to 160*, 180*, or 195* depending on what thermostat you just installed.
Remove the two, 1/2 inch bolts holding the thermostat housing on. The top one is much longer than the bottom one. The serpentine belt might be in the way of the lower bolt. If the belt is in the way, just loosen the tensioner and push the belt out of the way. 4. Remove the thermostat housing from the cylinder head.
Is there a coolant thermostat for the Jeep Cherokee?
Engine Coolant Thermostat. Your Jeep Cherokee is built to be tough while offering an impressive amount of utility. The thermostat seems like an unimportant part, but if yours becomes faulty, your engine starts to overheat. Maintain your ride’s performance by getting a thermostat replacement for Jeep Cherokee from your local AutoZone.
Where is the thermostat located on a car?
The thermostat housing is usually under the upper radiator hose. Unbolt the housing and remove the thermostat, using a screwdriver and pliers. Take the thermostat inside. There will generally be a number somewhere on the body, giving it’s opening temperature usually between 160 to 190°F or 70 to 90°C.
How can I get the thermostat out of my car?
The thick black hose runs from the side of your radiator and attaches to the top or side of your engine block with a tube clamp. Use a screwdriver to loosen the nut on the tube clamp and then pull the hose off of the engine. Set the end of the hose aside for now so you can access the thermostat housing on your engine.
What should the temperature gauge be on a Jeep Cherokee?
Refill cooling system with coolant. Make sure not to mix coolants as red and green coolant don’t mix well and can end up becoming a jelly like substance. The last step is to start your Jeep up and let it idle. The temperature gauge should climb to 160*, 180*, or 195* depending on what thermostat you just installed.
How to replace the thermostat on a 2001 Jeep Laredo?
⭐ 2001 Jeep Grand Cherokee Laredo – 4.0 – Thermostat – YouTube Video on how to replace the thermostat on a 2001 jeep grand cherokee laredo with the 4.0 engine. If our video(s) have helped you repair your vehicle, conside…
Can a Jeep Wrangler run cooler with a 180 thermostat?
On a cold day, yes an engine may run cooler with a 180 degree thermostat. Personally i changed mine out to a 180 the first week after i bought the jeep. My buddy has a 97 wrangler and has went through 3 radiators. After he changed to the 180, still has the same one.
How do you replace the radiator in a Jeep Cherokee?
Screw the new thermostat on, precisely in the location and pattern that you removed the old one. Wiggle the black hose back on and secure it with the hose clamp. Put the drain plug back in snugly. Fill up the radiator with a gallon of a solution that is half antifreeze, half water. Turn the Jeep on to circulate the antifreeze.
Does a Jeep Wrangler have a heater system?
HEATER SYSTEM 1988 Jeep Cherokee 1988 HEATER SYSTEMS Jeep DESCRIPTION Jeep vehicles use a blend-air type heater system. Wrangler models have a constant flow type system with engine coolant continuously flowing through heater core. Cherokee and Comanche use heater control valves. Coolant flow to heater core on these models can be stopped or diverted.
What is the correct tire pressure for a Jeep Wrangler?
Jeep Wrangler is a sport utility vehicle offered in 30 trims from 2005 to 2021, equipped with 15 original equipment tire size sets with recommended tire inflation of 29 psi to 43 psi.
What are the problems with the Jeep Wrangler?
The Jeep Wrangler has always been famous for off-road prowess – but never reliability. All new for 2018, the latest model carries on a tradition of sub-par jeep engineering with plenty of defects. According to the Highway Traffic Safety Administration ( NHTSA ), the most common problems are steering, structural and electrical defects.
Is Jeep Wrangler automatic or manual?
The 2020 Jeep Wrangler is available with two engine options: a 285-horsepower 3.6-liter V6 and a 270-horsepower 2.0-liter turbocharged four-cylinder. Both are available with an eight-speed automatic transmission and four-wheel drive, but only the V6 is available with a six-speed manual transmission.
What is the normal operating temp for a 2004 Cherokee 4.7?
What is the normal operating temperature be for a 2004 Cherokee 4.7. Would that also about 210 ? This weekend I will be replacing the Thermostat, thermostat sensor, radiator cap and doing a radiator flush. hopefully this will resolve the over heating issue. I have been noticing my clutch fan as been coming on more often.
Why does my Jeep Cherokee Run so hot?
Lol, but I’d be more likely to put in a 195 or slightly hotter stat in than leave it completely without one Engines with no stat will have trouble warming up, except on a hot day. Then they will run hot and not cool down from the coolant not spending enough time in the radiator to remove heat.
Can you run a no stat thermostat?
Engines with no stat will have trouble warming up, except on a hot day. Then they will run hot and not cool down from the coolant not spending enough time in the radiator to remove heat. But you can run a 180° stat. However this will not let it run cooler except on cooler days or light load.
Which is the best thermostat for a Jeep Grand Cherokee?
Shop AutoZone for Jeep Grand Cherokee Thermostat. Notes: 195 °F (91 °C), Engine coolant thermostat housing assembly. Includes housing, thermostat and seal. OEM recommended temperature Notes: 195 °F (91 °C), Engine Coolant Thermostat Housing Assembly. Includes housing, thermostat, gasket and seal. OEM recommended Temperature.
What should the temperature be on a Jeep Grand Cherokee?
OEM recommended temperature Notes: 195 °F (91 °C), Engine Coolant Thermostat Housing Assembly. Includes housing, thermostat, gasket and seal. OEM recommended Temperature. 0.0 out of 5 stars. Notes: 194 °F (90 °C), Engine coolant thermostat housing assembly. Includes housing thermostat seal and temperature sensor. OEM recommended temperature.
How can you tell if your car thermostat is closed?
Method 1 Testing at Home. At this temperature, you should see the thermostat begin to open. The part should be completely open when the water reaches approximately 10 degrees above the reading on the thermostat. If the thermostat is still closed at this point, it needs to replaced.
Can you replace the thermostat on a Jeep Wrangler?
Stop your Jeep vehicle from overheating and damaging the engine by getting a thermostat replacement for Jeep Wrangler. AutoZone offers the right parts at the right prices, so you can rest assured that you’re scoring the best deals when you shop with us.
Where is the temp sensor on a Jeep Cherokee?
Second, the temp sensor for the gauge is at the back of the engine in the head, the hottest place in the engine cooling system. It might be 220° there, but only 195 at the stat. It is a problem with a long engine block with the coolant coming all the way from the front.
Second, the temp sensor for the gauge is at the back of the engine in the head, the hottest place in the engine cooling system. It might be 220° there, but only 195 at the stat. It is a problem with a long engine block with the coolant coming all the way from the front.
Lol, but I’d be more likely to put in a 195 or slightly hotter stat in than leave it completely without one Engines with no stat will have trouble warming up, except on a hot day. Then they will run hot and not cool down from the coolant not spending enough time in the radiator to remove heat.
What’s the temp of a Jeep Cherokee in Texas?
Here in Texas at a pretty constant 100 plus degrees during summer months my jeep will run all day at about 190 degrees if I leave the fan on while Im driving.
How long does it take to replace the thermostat on a Jeep Cherokee?
If the temperature continues to climb past that point you may have air in the cooling system or a part of your cooling system may need to be replaced or upgraded. Replacing the thermostat on your 4.0 Jeep should only take about an hour or less, and is a fairly easy job even for the novice mechanic.
Where is the thermostat on a jeep XJS?
The problem with running hot in XJs is two fold. First, marginal cooling system to start with. Second, the temp sensor for the gauge is at the back of the engine in the head, the hottest place in the engine cooling system. It might be 220° there, but only 195 at the stat.
What happens if your car thermostat is stuck closed?
Learn more… Your vehicle’s thermostat opens to allow coolant to flow through the radiator and cool the engine down. However, if the thermostat gets stuck in the closed position, the coolant can’t flow through the radiator and can make your engine overheat.
The thick black hose runs from the side of your radiator and attaches to the top or side of your engine block with a tube clamp. Use a screwdriver to loosen the nut on the tube clamp and then pull the hose off of the engine. Set the end of the hose aside for now so you can access the thermostat housing on your engine.
Why does my Jeep Cherokee have too much coolant?
When the thermostat is stuck open, the vehicle will be getting too much coolant. On the other hand, if it is stuck in the closed position, the radiator will not be getting any coolant at all. If you do end up replacing the thermostat, make sure the new part is an exact match to your make and model of Cherokee.
What should I do about my Jeep Cherokee radiator?
Make sure your engine’s cooling system is working at its best by keeping your radiator filled with the correct amount of antifreeze from AutoZone. If you have not drained, flushed and refilled your Jeep Cherokee radiator recently, your engine might be in danger of damage from excessive heat.
When the thermostat is stuck open, the vehicle will be getting too much coolant. On the other hand, if it is stuck in the closed position, the radiator will not be getting any coolant at all. If you do end up replacing the thermostat, make sure the new part is an exact match to your make and model of Cherokee.
What happens when the thermostat on a jeep gets stuck?
A common problem with thermostats is that they can get stuck. When a thermostat is stuck, the valve is either continuously closed or open. In either case, it needs to be replaced immediately. When the thermostat is stuck open, the vehicle will be getting too much coolant.
Unscrew the two nuts securing the thermostat to the motor. Using a flathead screwdriver, drive a wedge between the thermostat and the motor, popping it out. Peel off the blue or black gasket that was sealed to the motor. It should come off easily. Place the new gasket on with the provided sealant.
How do you drain coolant from a Jeep Laredo?
Place a bead of RTV silicone gasket maker onto the gasket surface of the intake manifold and allow to to dry for 10 minutes before moving on. Place the thermostat housing onto the intake manifold of the Laredo and bolt it back into place. Open draincock on the radiator to drain the coolant from your Jeep Grand Cherokee.
Where is the thermostat located on a Jeep Cherokee?
Replacing a thermostat on most any car can be done with little auto repair experience. The thermostat is always in a visible and reachable spot. The Jeep Cherokee is even easier because the thermostat rests at the very top of the motor. The thermostat is a small piece that helps regulate the temperature of a vehicle.
Screw the new thermostat on, precisely in the location and pattern that you removed the old one. Wiggle the black hose back on and secure it with the hose clamp. Put the drain plug back in snugly. Fill up the radiator with a gallon of a solution that is half antifreeze, half water. Turn the Jeep on to circulate the antifreeze.
Here in Texas at a pretty constant 100 plus degrees during summer months my jeep will run all day at about 190 degrees if I leave the fan on while Im driving.
When to install a new engine cooling thermostat?
All thermostats eventually fail. Therefore, if the cooling system is already open for major repairs, such as water pump or radiator replacement, it is recommended to install a new thermostat simply as insurance against future breakdown. How do mechanics replace the engine cooling system thermostat?
How do you change the thermostat on a Chevy Equinox?
A new gasket is applied and the thermostat is re-installed in the correct orientation and with the temperature sensing cylinder facing downward towards the engine. The thermostat housing bolts are tightened to original equipment manufacturer (OEM) specifications using a calibrated inch-pound torque wrench.
Why does my Jeep Cherokee not have a thermostat?
(I.e., not letting coolant sit in the radiator/block long enough to transfer heat) Let’s go off of the assumption that all fans are properly shrouded and in good, working condition and the systems are full of a 50/50 mix of antifreeze and water and all air has been purged from the systems.