How do you replace rear wheel bearings in Toyota?
Place the new seal into the axle end, and carefully drive it in. For this seal, I found the front hub 2 1/8″ socket with a towel on the end was the perfect size to drive the new seal. Once the seal is seated, coat the lips of the seal with grease. Next, clean up the axle flange surface and replace the O-ring, or use gasket-maker instead.
How to remove an axle shaft from a Toyota?
This is how to build a tool to remove axle shaft from the bearing in order to replace the bearing on older style Toyota vehicles. This is 100% recyclable (scrap parts) materials used in this tool build. Loading…
Why does my Toyota Sequoia make a roaring sound?
Got an 04 two wheel drive Sequoia. Been noticing a roaring sound from the front drivers side for a couple of weeks now. Had the tires rotated and balanced and the noise hasn’t changed any. I also had new brake pads and rotors installed at the same time so this eliminates these.
How does SST work on rear wheel bearings?
The SST bolts to the bearing retainer/brake backing plate assembly using the original studs and nuts and then the whole thing is placed in the press. A few pumps later, the bare axle shaft should drop free from the rest of the assembly.
What’s the best way to replace a center support bearing?
Use a hammer and brass center punch. Step 16: Clean the ends of the driveshaft. Once the center support bearing has been removed, clean all ends of each driveshaft with solvent and prepare to install the new bearing.
How do you replace a wheel seal on a Toyota?
You should be able to remove and install this seal by hand. Just pop it out, push the new one in, and apply grease to the seal lip. To begin reassembly, place the backing plate onto the axle shaft, then the new wheel bearing, and then the bearing retainer.
How are driveshafts attached to center support bearings?
The two driveshaft’s that attach in the center support bearings are attached on opposite sides of the vehicle as well. The front drive shaft is attached to the output shaft coming out of the transmission, while the rear driveshaft’s propeller shaft is attached to the yoke that comes out of the rear axle differential.
How do you replace a Toyota 4Runner brake cable?
Once the tire is off the vehicle, remove the retaining pin from the emergency brake lever mechanism at the backing plate and move the cable out of the way. 1990 and later 4runners will need to remove the brake drum, unhook the brake cable from the lever inside, unbolt the cable sleeve from the backing plate, and slide the cable out.
When to replace rear wheel bearings and seals?
When the stock breather is unable to vent the diff, the internal pressure will find relief somewhere in the system: usually at the axle seal. So, if you have a leaking seal, be sure to check the breather for proper operation. Or better yet, replace it with an extended breather. The brake assembly and axle/backing plate prior to removal.
How do you replace a rear wheel axle?
The first step is to use the 20-ton shop press and Rear Wheel Axle Bearing Puller & Tone Ring Tool/Installer SST to remove the ABS tone ring and inner retainer from the axle. And to use the SST, I had to pound out one of the studs that holds the backing plate to the axle housing.
What causes an axle seal to fail on a Toyota?
Common causes of axle seal failure are plugged differential breathers or worn wheel bearings. Less common causes can be a bent axle housing or shaft. When the stock breather is unable to vent the diff, the internal pressure will find relief somewhere in the system: usually at the axle seal.