How do you replace a tail light wire?
Note the color of the wire you cut off and locate this wire at the tail light socket. Cut the wire off, leaving enough wire still connected to the socket to splice onto the new 16 gauge wire using another butt connector. Tape the connections very securely. This will help prevent corrosion which will reduce the voltage to the light.
What to do if your tail light has no power?
If power is found in the socket, the problem is a bad ground wire or connection. If no power is found, the wire must be visually inspected and probed along its length until power is found. Disconnect the first tail light wiring harness connection and probe the car side for power.
When to take a tail light bulb to the mechanic?
If the bulb is fine, your car may have a deeper electrical problem. If the fuse, taillight wires, and bulb are all in good shape, it’s time to take the car to the mechanic. When you remove a bulb for replacement, you should inspect the socket for burnt contacts and the tail lamp for burnt contacts or melted socket boards.
When do you need to replace a tail light fuse?
On most new cars, the fuse would have to be removed to be checked due to the arrangement of the fuses. If the piece of metal inside the taillight fuse is intact, the fuse is still good. If the piece of metal looks broken or fractured, the fuse is blown and will need replacing.
What’s the best way to replace tail lights?
Start by disconnecting the car battery. This will reduce the risk of shock or electrocution. Once you have done this, you’ll need to access the tail lights through the trunk or rear hatch. It will be helpful to do this in a well-lit place, or you can grab a flashlight.
Why does my tail light keep going out?
As you look around, you’ll notice that this isn’t an uncommon problem. Taillights fail frequently for many reasons. The bulb itself may have burned out, as these don’t last forever. There could faulty wiring or a disconnected wire somewhere. Accidents could cause the light to crack or break as well.
What should I use to replace my car battery?
Make sure you grab a screwdriver, socket wrench and a pair of gloves before starting the replacement process. Safety is critical anytime you are working with bulbs and wires. Start by disconnecting the car battery. This will reduce the risk of shock or electrocution.
How to replace turn signal lights and brake lights?
When you’re ready to put the assembly back in the housing, first hand-tighten the bolts before using a ratchet. It’s important to not tighten these too much, as they have a tendency to crack or break the housing. Replace the bulb holders. These should look different than the turn signal lights and brake lights.