How do you replace a Saab blend door?
The replacement is white. Most 2000 and later cars have the white ones. SEE Service Bulletin 854-2461 for details. Clear the codes in the ACC system using the Tech 2 tool and recalibrate the system. If you do not have a Tech 2 just recalibrate by pressing auto and off simultaneously.
How does a 9-5 a / C blend door repair work?
9-5 A/C BLEND DOOR REPAIRThe shaft that connects the stepper motor to the blend door fails as shown. The original repair part , manufactured from aluminum, is shown attached to the servo above.
Where is the stop arm on a blend door?
You will want to position the stop arm over the screw that is shown just to the left of the stop arm in the picture. Be aware that it takes quite a bit of torque to get the stepper motor to start turning, but once it starts to move, it goes easier.
How do you fix a broken yellow blend door?
Rotating the yellow blend door shaft clockwise, may help, and sometimes holding it in place with a pick helps when attempting to index the parts. Then, While supporting the other part of the broken shaft from within the case, press the two parts together.
How long does it take to repair a Saab blend door?
The new process can be completed in the vehicle in approximately 1 hour. First one must gain access to the servomotor by removing the lower dash cover on the affected side. The process shown is for the left side. Remove the servomotor, temp sensor, and vent “elbow”.
What’s the problem with my Saab 95 se?
I have a 2001 saab 95 se and half of the cars heat works the other doesnt only cold are comes out and its not a good feeling in the winter. Does anyone know how to fix that problem ? or whats wrong with it ? only the drivers side vents push cold air all others work fine even in the back.
You will want to position the stop arm over the screw that is shown just to the left of the stop arm in the picture. Be aware that it takes quite a bit of torque to get the stepper motor to start turning, but once it starts to move, it goes easier.
9-5 A/C BLEND DOOR REPAIRThe shaft that connects the stepper motor to the blend door fails as shown. The original repair part , manufactured from aluminum, is shown attached to the servo above.