How do you replace a radiator step by step?
- Step 1: Raise and support the vehicle.
- Step 2: Drain the coolant from the radiator.
- Step 3: Disconnect the radiator reservoir hose.
- Step 4: Remove the upper radiator hose.
- Step 5: Remove the lower radiator hose.
- Step 6: Disconnect the cooling fan electrical connector.
- Step 7: Remove the cooling fan mounting bolts.
Does it matter which way you install a radiator?
In terms of which side each valve should go, in the majority of cases this should not matter e.g. the lockshield and wheel head or thermostatic valve can go either side of the radiator due to the nature of the system being on a loop however if you are fitting thermostatic valves then generally these go on the incoming …
Can you add a radiator without draining the system?
Yes you can drain down ” just enough” if you are confident about it, however it’s no big deal to drain down the whole system, if you turn all the other radiators off they wont drain down anyway and that makes re-filling easier.
What’s the first step in installing a new radiator?
The first step involves removing and cleaning old PTFE for radiator valve tails using a tail key and apply new PTFE ready for fitting to the new radiator. It’s vital that you get the tape wrapped around the valve in the right direction, so if you’re holding the valve in your left hand, make sure the tape is rotating round in a clockwise direction.
How do you mount a radiator on a car?
Install the radiator mounting bolts using a wrench or ratchet and socket of the appropriate size. Step 16: Connect the transmission cooler lines. Connect the transmission cooler lines to the radiator using a flare nut wrench to prevent rounding off the fittings. Step 17: Mount the fan.
How do you drain coolant from a radiator?
Step 1: Raise and support the vehicle. Safely support the vehicle by jacking it up and supporting it with jack stands. Place a wheel chock behind the rear wheels and set the parking brake. Step 2: Drain the coolant from the radiator. Open the petcock valve or remove the lower radiator hose to drain the coolant from the radiator.
How do you run a steam radiator through the floor?
Run the pipe from below the floorboards to the new radiator. You can use the pipe cutter to open the steam pipe, although you should be sure that you have turned off all hot water sources before you do this. Push the pipe through the hole you made in the floor, leaving a protrusion about 3½ inches above the level of the floor.