How do you remove wheel bearings from a Mazda 3?
Unbolt the tie rod end from the steering knuckle using the 3/8-inch ratchet and socket. Unbolt the upper and lower ball joint nuts from the steering knuckle and remove the steering knuckle from the vehicle. Set the steering knuckle in a press and remove the hub bolts with the press. Remove the hub from the steering knuckle.
How do you remove a steering wheel bolt?
Remove the steering wheel bolt behind the steering wheel. Pull the steering wheel off the steering column. Remove the four screws securing the steering column to the vehicle. Carefully remove the column from the vehicle, pulling the electrical connector wire out through the bottom of the column.
How to remove replace steering wheel and airbag on a Mercedes?
You need to remove the steering wheel or the clock spring on this video but you can see that that once you remove the steering wheel they are easy to replace. Flat screwdriver. Torx set. Hex 10 mm wrench. Step by step instructions on how to remove the steering wheel and airbag on Mercedes-Benz.
How do you replace the steering wheel on a Ford Ranger?
If your air bags have been used, you will have to install new ones. Turn the Ranger’s steering wheel to its neutral position. Turn the Ranger’s engine off. Open the hood and use a socket wrench to remove the negative battery cable. Allow five minutes to pass for the air bags to disengage. Remove the two screws on the cover of the steering wheel.
How do you disassemble a steering wheel?
This can be either held in place by a set screw, or through a small clip. Once the horn is disconnected from the steering wheel you need to remove the center retaining nut and washer. Once the center nut is removed, grab the wheel with both hands. With even force on both sides, pull the steering wheel towards you in an upward motion.
Can you install an aftermarket steering wheel on a car?
In this episode of Mighty Car Mods Marty and Moog show you how to install an aftermarket steering wheel in your ride for better awesomeness, updated coolability, and increased attractivety! If your car has an airbag then do not use this process. There is more info on the MCM Forum.
How do you remove a steering column cover?
Once the steering column cover is removed you can then get at the turn signal indicator. Remove the canceling cam as well as the screws that hold the turn signal in place. There are a few screws on each side that will need to be removed. Slide the turn signal upwards to remove it.
How do you remove ignition cylinder from steering column?
Remove the ignition cylinder from the steering column by unscrewing the three screws around the collar. Push the tab located on the top right of the cylinder and pull the ignition out. After these are taken care of you can remove the other remaining bolts and springs on the lower steering column.