How do you remove Governor from Honda variator?
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How do you remove the governor from a Honda Metro scooter?
Wrap the strap around the wheel, tighten it and jam the handle of the wrench underneath the rear pulley wheel. This will give you sufficient leverage to remove the bolt holding the wheel in place without turning the wheel. Unscrew and remove the bolt holding the front pulley wheel in place. Pull the governing washer off of the front pulley rod.
What happens if you adjust the Governor of an engine?
In the event that they do need adjusted, here is how to do it. One of the most important parts of your engine is the engine governor. An improperly adjusted governor can shorten your engine’s life. If engine speed is not controlled, the engine will destroy itself. Never run an engine over speed, especially without a load attached to it.
How do you adjust the governor on a LEV engine?
For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle. To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open.
Can you remove the governor from a predator engine?
Thread by kc where the governor was ignored by just not using it. Scroll down a bit. I will say that this does not remove the plastic gear controlling the governor from the equation, meaning that it might be possible that the gear can’t handle being pushed past the design speed of 3k rpm.
How to remove the governor for a 50cc Honda Metro scooter?
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
What does a mechanical governor on a scooter do?
Mechanical governors limit the speed of the vehicles in which they are placed. Typically installed for safety purposes, some scooter governors allow the scooters to be driven at a low enough speed so that you are not required to acquire an M-class license.