How do you remove a window regulator from a door?
Window Regulator Removal: STEP 1: Gain access to the window regulator by removing the interior trim panel. STEP 1a:The interior trim panel is typically held to the door using a variety of screws an/or hidden panel retainers (Photo A). Metal screws are usually used to secure the handle area to the door (Photo B).
What should I use to lubricate my window regulator?
If there is not much grease present, white lithium grease works well to lubricate the slide area. • Aftermarket window tinting can cause the window to travel slower and put additional strain on the window regulator assembly. • Window run channels should be cleaned and lubricated before installation of a new window regulator assembly.
What’s the best way to replace a glass door?
STEP 1: Set regulator into door and attach with proper hardware. STEP 2: Maneuver glass and regulator together to match up mounting points. STEP 3: Attach glass to regulator. STEP 4: Plug in switch temporarily and run window up and down to ensure that it moves freely. STEP 5: Replace plastic water barrier sheeting.
How do you remove glass from a library door?
Pull/slide the roller pins on the regulator out of the window channel (there is a slot in the middle for the front roller to fall through). This may require some wiggling around. Remove the glass from the door. Unbolt and remove the vent window assembly. Pull the regulator out of the holes in the inner door.
How do you remove door glass on a MGB?
Some early MGBs have a removable window stop (the small metal ‘box’ in the door bottom that the lowered door glass rests on, originally topped with a horsehair pad). If you are so lucky, just unbolt that and lower the glass to uncover the rivets. Later cars had this door stop welded in place and the only solution is to remove the door glass.
What’s the best way to remove door glass?
Fish the door glass with metal track attached down past the rubber seal, taking care not to tear your new seal. Straight down worked best for me. Push the glass into the front track and then fish the rear track into place on the back of the glass.
What’s the best way to install door glass?
Push the glass into the front track and then fish the rear track into place on the back of the glass. Install the rear track fasteners but do not tighten. Slide the door glass up and down in its tracks until it slides freely but is tight enough to stay in place when you let go of it.