How do you remove a starter motor from a car?
Pull the starter motor out of the engine. Slip a screwdriver through the starter motor sprocket, accessible from the left side of the engine, to support the starter chain and sprocket while the starter motor is removed.
Can a damaged starter be removed from a Kawasaki Bayou?
Starter motor failures are a common problem, especially with older Bayous; however, a damaged starter is not a deal buster. Removing the starter is surprisingly simple, allowing a Bayou owner with limited technical know-how to remove and replace the starter, using only common mechanics tools. Place a oil drain pan directly below the engine.
What happens if you tap the starter motor?
Don’t tap of the starter motor during the removal or installation process. The shock of impact, even through light taps, can damage the starter motor’s sensitive internal components. Do not dump used engine oil into a trash can. Have the oil recycled at your nearest auto parts store or Kawasaki repair center.
What causes a zipper slider to not close?
This is a problem that happens with use. The slider gets worn or loose or wide apart ; a small gap in the slider is enough for the zipper to refuse to close. Consequently, the teeth will not mesh together to close the zip. How to repair the zipper slider
What should I do if my starter is not working?
The starter pinion gear engages this wheel to make your car engine crank. Remove the starter motor and set your transmission gear to neutral. Rotate the crankshaft manually using a ratchet. There is a pulley at the front or bottom of your engine block. The pulley should move as you watch how the pion gears are reacting.
How to remove a car starter from the engine?
Remove the starter retaining bolts then the starter. 1 Be sure to use the correct size socket, otherwise you risk damaging the bolts. 2 You may need to pull on the starter with a bit of force in order to remove it from the engine once the bolts have been… More
Do you need to disconnect the positive cable on a car starter?
You will not need to remove the positive cable on the battery. Always disconnect the battery before servicing the electrical system in your vehicle. Jack up the vehicle if need be. In some applications, you may need to jack up the vehicle in order to access the starter.
How to disconnect the starter from the solenoid?
Disconnect the wiring to the solenoid. Depending on the application, there could be a few different types of connections transferring power from the electrical system of the vehicle to the starter. Use the appropriate hand tools to disconnect any connections going to the starter.