How do you remove a spring from a suspension spring?
Lower the jack to relieve tension from the lower control arm. Step 6: Lower the control arm and remove the spring. Once the bolt has been removed, and the jack lowered, the lower control arm will easily be lowered which will permit you to remove the spring.
How do you remove rear suspension from car?
Before taking off any parts or beginning this job, always disconnect power from the battery. Remove the positive and negative terminals from the battery. Step 2: Locate the springs and the strut connections. The diagram above shows the basic setup of the rear suspension on most passenger cars and SUVs.
Where do you attach a spring to a car?
You’ll notice that the spring is attached to the lower control arm and a top bushing mount on the body. Step 3: Raise the vehicle. It’s recommended to work on one wheel at a time when completing this project, but you can raise the entire rear end and place the car on jack stands.
How do you install a spring on a riding mower?
Place a jack underneath the lower control arm and begin to slowly jack upward. With one hand, support the new spring until the top has been placed firmly in the upper body mount. Raise the jack until the lower control arm is equal with the lower control arm bushing. Insert the lower control arm bolt and tighten the nut on the back side.
Lower the jack to relieve tension from the lower control arm. Step 6: Lower the control arm and remove the spring. Once the bolt has been removed, and the jack lowered, the lower control arm will easily be lowered which will permit you to remove the spring.
How do you replace leaf springs on a car?
Make sure the vehicle is in “Park.” Loosen the lug nuts slightly on both the rear wheels. Raise the rear end with a hydraulic jack and put jack stands under the rear axle to keep the vehicle raised. Loosen the remove the lug nuts, then take off both rear wheels. This will give you access to the rear leaf springs.
How to replace coil springs in front of car?
Steps to Replace Front Coil Springs 1 Loosen the lug nuts, then raise the front of the vehicle using a jack. Secure it with jack stands, and then remove the lug nuts and wheels.
Do you need to remove shock mount on leaf spring?
Left: If your car is equipped with a rear sway bar, you can use it to help hold the rearend stable. Right: With the four U-bolt nuts removed, you can remove the lower plate/shock mount and rubber pads. The bolts for the rear shackles insert from opposite sides.
What’s the best way to remove a coil spring?
Then you slowly let the jack down again. As it lowers, the coil spring will gradually decompress until there is no force left. Then you can undo the tie-down straps. The lower A arm will probably drop down and the coil spring can be removed.
What’s the best way to remove a leaf spring?
Removing the Old Springs Wear safety glasses to protect your eyes. Soak the spring’s nuts and bolts in oil. Remove the bolt from the shock pads with a ratchet wrench. Loosen the U-bolts to remove them. Unscrew the eyelet bolts on the spring’s ends. Repeat the steps to remove the other leaf spring.
Removing the Old Springs Wear safety glasses to protect your eyes. Soak the spring’s nuts and bolts in oil. Remove the bolt from the shock pads with a ratchet wrench. Loosen the U-bolts to remove them. Unscrew the eyelet bolts on the spring’s ends. Repeat the steps to remove the other leaf spring.
Can you remove the pins from coil springs?
You may want to use padding so the finish on your suspension parts doesn’t get scratched. The frame of the car won’t lift because it is strapped to the jack, so the jack will hold the lower A arm in place. Now, you can safely remove the outer pins so the end of the A arm is free.