How do you put a front license plate on a car?
Align the license plate with the holes in the bracket. Locate the holes in the corners of the license plate and the bracket. Place the license plate into the bracket so the holes are aligned. If your bracket includes a frame that fits over the license plate, line its holes up with those in the plate and bracket.
What are the states that require a front license plate?
Either way, we help break down which states, including Texas, California and Massachusetts, require the oft-dreaded front license plate and how people try to get around it. There are 30 states plus Washington D.C. that require a front license plate. The states are as follows:
Where do you get the screws for a new license plate?
If the bracket held an old license plate, it’ll come off when you remove the screws. If your vehicle is new, the license plate bracket screws might be in the glove compartment. If you have no screws, you can pick up some license plate screws at a nearby hardware or automotive store. Check for a license plate frame.
How tall should a front license plate be?
Mounted right side up and reading left to right. No more than 60 inches off the ground. Uncovered, unless the cover only protects the registration tabs (which front plates don’t have). With its original reflective coating intact.
What’s the best way to install a front license plate?
Drill 1⁄ 8 inch (0.32 cm) pilot holes into the bumper. After you’ve marked your guide holes, set the bracket or license plate aside. Use a power drill and a 1⁄ 8 inch (0.32 cm) bit to drill shallow pilot holes into the bumper. Drill your pilot holes only about 1⁄ 8 inch (0.32 cm) deep into the bumper.
Do you need a front license plate on a Subaru?
Subaru does not open these holes because there are states that do not require front license plates. Some Subaru models come with holes in the front bumper, (some square, some round,) which are for non-U.S. plates.
How do you remove a front license plate?
Remove the screws in the bracket that secure the license plate. Locate screws at the corners of the license plate bracket on your front bumper. Turn them counterclockwise with a screwdriver to remove them, then keep them in a safe place so they don’t get lost. If the bracket held an old license plate, it’ll come off when you remove the screws.
Are there any states that do not require a front license plate?
Every state requires at least a rear license plate, but as previously mentioned, there are 19 states that do not require a front plate. These states are: Alabama. Arizona. Arkansas. Delaware. Florida. Georgia.