How do you program a key fob for a 2010 Hyundai Santa Fe?
Stick the key to your Hyundai into the vehicle’s ignition cylinder. Turn the key to the “ACC” or “Accessory” ignition position. Hold down the “Open” or “Unlock” button on the keyless entry FOB until the vehicle’s lights flash. The keyless entry FOB is now reprogrammed to your Hyundai vehicle.
How do you start a Santa Fe without a key fob?
How do you remote start a Hyundai Santa Fe? With your foot off the brake pedal, press the button on the remote control transmitter. The parking lights will turn on and the driver’s door will unlock (if locked), indicating the vehicle is now running via remote start.
How to program Hyundai Santa Fe keyless entry remote?
One 2010 Hyundai Santa Fe Keyless Entry Remote – new condition. Programming instructions are not included with the purchase. This remote has to be programmed by your dealer or local car locksmith (you can look it up here: Locksmith Search ). It takes less then 5 minutes.
Where is the program FOB on a Hyundai Santa Fe?
1. Open the drivers side door 2. Turn the Vehicle ignition to the ON position (Do not start the vehicle) 3. Locate the disarm/program button. (look closely, it is located on the wiring harness just inside the lower dash. it could be located just inside the fuse cover.) 4.
Are there any free keyless entry instructions for Chevy Silverado?
We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.
How do you change a key fob in a car?
Turn the ignition to the “ON” position. Press and hold the found button under the dash for 10-15 seconds, the horn should beep 3 times. Press the “Panic” button on the new key fob. The horn should sounds once. Turn the ignition off for at least 10 seconds. The car should start now. This was a life saver.
One 2010 Hyundai Santa Fe Keyless Entry Remote – new condition. Programming instructions are not included with the purchase. This remote has to be programmed by your dealer or local car locksmith (you can look it up here: Locksmith Search ). It takes less then 5 minutes.
1. Open the drivers side door 2. Turn the Vehicle ignition to the ON position (Do not start the vehicle) 3. Locate the disarm/program button. (look closely, it is located on the wiring harness just inside the lower dash. it could be located just inside the fuse cover.) 4.
We strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on NorthCoast Keyless.
Turn the ignition to the “ON” position. Press and hold the found button under the dash for 10-15 seconds, the horn should beep 3 times. Press the “Panic” button on the new key fob. The horn should sounds once. Turn the ignition off for at least 10 seconds. The car should start now. This was a life saver.