How do you program a Code Alarm Remote catx1b?

How do you program a Code Alarm Remote catx1b?

To reprogram the remote transmitter please perform the steps below:

1. Turn the ignition ON.
2. Press and hold the valet/override button.
3. Within 10 seconds the system will chirp (3) three times.
4. Press 1 button of each transmitter you wish to program.
5. The system will respond with 1 light flash for each accepted transmitter.

How do you program a valet remote starter?

Press the valet remote push-button to access the channel that you want to program: once for “Arm/disarm,” twice for “Trunk Release” and three times for “Remote Start.” The valet push-button is usually located under the driver’s side panel, and it must be pressed within 15 seconds of opening the door.

How do you get code alarm out of valet mode?

To enter or exit valet mode simply follow the 4 steps outlined below: Turn the vehicle’s ignition ON. Push and hold the programming/valet button….To by-pass the alarm system:

1. Open the vehicle door.
2. Turn the ignition key to the ON position.
3. Within 10 seconds, press and release the valet push button switch.

What do you do if your remote start doesn’t work?

Double check your engine coolant and oil temperatures: If the engine coolant temperature is too high or the oil pressure is too low, remote start is disabled! After you have let the car cool down for 5-10 minutes and rechecked the levels, retry the start procedure.

What is the valet button on my remote?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.

How do I reset my valet remote starter?

Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.

What is valet mode on a remote starter?

Valet mode is a safety convenience feature standard on all Arctic Start remote start and security systems. Valet mode disables all system features other than lock or unlock; such as, remote start, alarm triggers, and trunk release.

How do you use a remote start prestige?

Operating the Prestige APS995 Remote Start Security System

1. Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain transmitter. The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren sounds one chirp.

How do I program prestige 143bp?

To program the remote to your system:

1. Turn the key to ON.
2. Press the Valet/Programming button 3 times.
3. Press the Lock button on the remote for up to 3 seconds.
4. Press the Valet/Programming button once.
5. Press the Unlock button on the remote for up to 3 seconds.