How do you program a 2007 Saturn remote?
PRESS and HOLD the Trip Odometer Reset Button for 3 seconds until “REMOTE KEY LEARNING ACTIVE” displays. Vehicle is now in Programming Mode. PRESS and HOLD LOCK and UNLOCK buttons at the same time on the first remote for 15 seconds. The vehicle will emit a sound indicating successful programming of the remote.
What to do if your GM remote is not working?
If the display still does not appear, contact your nearest GM car care professional. Press the Set/Reset button until “Remote Key Learning Active” appears on the display. The Set/Reset button should be near the Vehicle Information button.
Is it possible to program a GM keyless remote?
If your car is a GM post-2010 model, you should contact your nearest car care professional. After 2011, most GM models have already synced transmitters that come with the car when you buy it. Once you determine which category your car fits in, programming a keyless remote becomes a very easy process, only involving a few quick steps.
What does a chime sound like on a GM remote?
You should hear a noise that sounds like a chime. This means that your transmitter has been successfully synced. If that does not happen, it is likely the sync is off, in which case you will have to restart the process. Repeat the previous step for each transmitter, up to four. Do this in rapid succession.
How do I lock and unlock my GM remote?
Press the lock and unlock buttons down on the remote at the exact same time. Hold the buttons down for at least 15 seconds. This can be done for up to four remotes; just hold the lock and unlock buttons down for 15 seconds on each remote.
How long does it take to program a Saturn Remote?
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
How do you program a Saturn key fob?
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
What’s the best way to program a GM remote?
Sit comfortably in the driver’s seat, and make sure that your transmitter is close enough to the steering wheel and internal locks. Pull on the internal handles of each door to make sure that they are closed tightly. Turn your key to the “Accessory Power” position.
When did GM stop using keyless entry remotes?
Vehicles made between 2007 and 2010 will either be equipped with the Vehicle Information Center (VIC) or not. There are different methods for both. All vehicles from 2007 or earlier used the same type of keyless entry remote.