How do you flush a heater core with a garden hose?

How do you flush a heater core with a garden hose?

Now, here’s how to perform a heater core flush:

1. Step 1: Locate the Heater Core. First thing’s first.
2. Step 2: Disconnect the Heater Hoses.
3. Step 3: Apply the Pressure.
4. Step 4: Hit it with the Hose.
5. Step 5: Reconnect the Heater Hoses.
6. Step 5a: Flush your entire cooling system with Thoro-Flush.
7. Step 6: Refill the Coolant.

What size hose goes to heater core?

Heater Core is 0.625 and heater core hose is 0.63, close enough.

Can a garden hose be used to flush a heater core?

If not, you can use a garden hose for the same purposes. Place the airline or hose in the outlet hose from the heater core. You will need to use a water hose to flush the system either way, but compressed air may move harder to break blockages. Seal the line.

Where does the coolant go after flushing out the heater core?

The inlet hose may have a heater control valve which regulates the amount of coolant flowing into the heater core. The outlet hose will typically run straight to the radiator or cooling system reservoir to return the coolant after flowing through the heater core.

Where is the heater core located on a car?

Locate the heater core on the vehicle’s firewall. The heater core inlet and outlet pipes are usually located on the firewall separating the engine from the cabin of the vehicle. Its location will vary from vehicle to vehicle so if you have difficulty locating the inlet and outlet hoses, refer to the service manual for your specific vehicle.

What should I do if my heater core comes out?

Take care not to damage outlet port or you will have to replace the whole heater core. If the hose is old and caked onto the outlet port, you may have to replace the hose as removing it will likely damage the seal. Liquid will most likely come out as well so have the rags ready to clean up any spilled coolant. Step 3: Attach garden hose to outlet.