How do you check a distributor Ignitor?
If you want to check the ignitor, disconnect ir from the coil and put a test light at the coil wires. Crank the engine, you should have a blining light if the ignitor works.
How to diagnose an ignition system problem?
Ignition System Diagnosis Using Visual Inspection • Check all spark plug wires for proper routing. All plug wires should be in the factory wiring separator. • Check that all spark plug wires are securely attached to the spark plugs and to the distributor cap or ignition coil(s).
What kind of igniters do aircraft engines use?
Comprehensive tests have showed spark rate variation was cut by 50%. We build high tension and low tension turbine igniters for aircraft main propulsion engines, auxiliary power units and a wide range of turbine engines for industrial applications.
Who are the owners of unison ignition systems?
At Unison, a wholly owned GE subsidiary, we are unmatched in our ability to engineer and integrate all components of the ignition system. Unison exciters are available for Industrial, L&M, Aerospace and main propulsion or APU engines.
What makes a unison turbine igniter so good?
Unison turbine igniters are built with induction-fused glass seals to resist high combustor pressures, and may include exotic metal tip designs for high temperature performance and longevity. Optimized semiconductor geometry and composition resist spark erosion even in the most demanding continuous duty service.
When to use ignition switched power in a car?
When a car is running (engine on) the ignition (on) source is live (supplying 12v). You can however use ignition switched power when the car is not running but the key is in the ignition (on) position. The ignition (on) source should be used when dealing with high-current applications which include some of the following:
Can a ignitor be used by more than one distributor?
The Ignitor electronic ignition is far from being universal. Each kit is designed specifically for the distributor type. However, our kits will often fit many distributors from the same manufacturer. A kit that has been designed for a particular distributor type may also fit other distributors that use the same point set, cap and rotor.
What do you need to know about Honda igniter?
The next headings contain all of the essentials you’ll need to know, like: common symptoms, tools needed to perform the tests, do’s and don’t’s, and a little working theory of how the Honda (Accord, Civic, or Odyssey) igniter works. In a nutshell, when the igniter or ignition coil fails in your Honda (Accord, Civic, or Odyssey), it won’t start.
How do you turn off a pertronix ignition switch?
Attach positive (red) lead of your voltmeter to the positive side of the coil, and the negative (black) lead to an engine ground. Turn the ignition switch to the run position. Now read the voltage at the positive coil terminal. Turn the ignition switch off. If the voltage measured is approximately 12 volts, no resistance wire is present.