How do you change timing belt on Honda CRV?
Install the lower and middle timing covers. Install the crankshaft pulley and tighten the bolt to 130 ft. lbs. (177 Nm). WARNING If any binding is felt when adjusting the timing belt tension by turning the crankshaft, STOP turning the engine, because the pistons may be hitting the valves.
How much does it cost to change timing belt on Honda Civic?
I show you how easy it is to change the Timing Belt and tensioner on this 1998 Honda Civic 1.6L. Timing belt kit (Belt, pulley & tensioner) all cost under “$55” for the parts. The procedure may be different for other vehicles but the principles are the same.
Where is the alternator belt on a Honda CRV?
The 2.0L engine uses separate drive belts for the air conditioner, alternator and the power steering pump. The outer most belt of the three belts is the power steering belt, followed by the air conditioner belt, and lastly the alternator belt. Therefore to remove the air conditioner belt, requires power steering belt removal.
What kind of belt does a 2.0L engine use?
Check the engine operation and road test. The 2.0L engine uses separate drive belts for the air conditioner, alternator and the power steering pump. The outer most belt of the three belts is the power steering belt, followed by the air conditioner belt, and lastly the alternator belt.
How to set timing belt on Honda CRV B20B?
Rotate the crankshaft five or six revolutions to set the belt 4. Set the No. 1 piston at TDC 5. Loosen the adjusting bolt 1/2 turn (180º) only 6. Rotate the crankshaft counterclockwise three teeth on the camshaft pulley 7. Tighten the adjusting bolt to the specified torque – 54 N/m (5.5 kg/f.m, 40 lbf·ft) 8.
What’s the best way to change a timing belt?
The important thing is to make sure that your timing belt is as tight as it should be. Drive out the crankshaft seal with a hammer and punch. This is the rubber seal around the crankshaft and the timing cover. Tap the new crankshaft seal into the timing cover. The seal should be seated into the correct place on the timing cover.
How do you change the timing chain on a water pump?
Remove the belt. Once tension is released, the belt should slide off of the other pulleys easily. Remove the heater hoses from the water pump. If your model has heater hoses attached to the water pump, loosen the hose clamps with a screwdriver and slide them back onto the hose. Wiggle the hose and pull it off of the water pump.
What should I do to tighten my timing chain?
Tighten the chain according to your car manual’s specifications. Some chains are tensioned by adjusting either the crankshaft gear or the camshaft gear, while others have an automatic tensioner. This will vary by make and model of your car. The important thing is to make sure that your timing belt is as tight as it should be.