How do you change a drive shaft?
Wear protective eyewear and gloves before you begin.
- Mark the Driveshaft. Mark the driveshaft orientation before beginning.
- Remove Driveshaft Bolts. Remove the shaft differential flange mounting bolts.
- Remove Driveshaft Flange.
- Remove Driveshaft.
- Check U joints.
- Reinstall Driveshaft.
- Reinstall Flange Bolts.
How do you remove an axle from a Honda Civic?
Attach a 17mm socket and ratchet on one end, and a 17mm wrench on the other. Hold wrench in place while the ratchet undoes the bolt. Once bolt is loose, use the hammer to get it off. Figure 7. As you can see, the axle goes right through the strut. Hence the need to remove it. With everything out of the way, the axle is ready to be pulled out.
How do you take an axle shaft out of a car?
Wiggle and twist the steering knuckle free from the strut. When the two have separated, the axle shaft should have slid partially out. Pull the shaft out with your hands. Removal of this shield will allow pry bar access to the “ears” (pry bar leverage points) of the axle’s inner bearing cup.
How do you get the drive axle out of the steering knuckle?
Push the drive axle out of the hub and steering knuckle assembly using a gear puller. If necessary, loosen but do not remove the strut-to-steering knuckle bolt to push the axle free from the steering knuckle.
How to replace CV axle shaft and output shaft?
Bolt on the suspension strut to the steering knuckle along with the brake hose bracket bolt. Install the wheel and remove your jack and jack stands. Torque the axle shaft nut to around 150 lbs. Applying your body weight to the breaker bar should put you close to that torque. Fill your transmission with ATF.
How do you replace a CV axle in a car?
You can remove the band from the inner boot to help the old axle pass through. Insert the new CV axle into the transmission housing. Just as you removed the old CV axle, insert the new one into the same spot in the transmission housing. The peg will slide all the way in until the axle is flush against the housing.
How do you remove a drive axle from a car?
Place a steel punch in the edge of the brake rotor and rotate it until it contacts the brake caliper. Working against the punch, loosen the axle nut. There may be a cotter pin or staked edge keeping the nut in place.
How to replace axle shaft 01-05 Honda Civic?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: -I6CQftCgUO0U8JA) Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How to remove drive axle from Haynes car?
1 The axle nut requires a large amount of torque to loosen, if possible break it free before raising the car. 2 Loosen the lug nuts. 3 Open the hood, block the wheels, then raise the car and support it on jack stands. 4 Remove any splash shield or access panel to expose the inner CV joints.