How do you alignment a front wheel on a can Am Spyder?
Use a trolley-jack or similar to briefly lift a wheel clear of the floor and rotate it if necessary. With two legs with L-collars at the top, poke the legs of the standoff through the wheel spokes so that they attach to the brake disc.
Where to place lasers on can Am Spyder?
Place the lasers, pointing rearward, as close as possible to hub height, also Target scale height, 270mm above the floor. Use a set-square ‘along’ the bike to place masking tape on the floor exactly below the rear edge of the wheel rim, then slide the square on the floor ‘across’ the bike until it just touches the laser beam ( photo →.).
What kind of alignment Kit do I need for my Spyder?
The Alignment Kit consists of : ● 2 yellow Shinty LE007 magnetic-base Laser Levels ( batteries included ) NB: These levels are accurate but made of plastic. They may be knocked out of alignment if handled roughly or dropped.
Why are the wheels spread out on a Spyder?
Because the Spyder is rear-wheel drive, always pushing the mass of the front-end geometry, the wheels spread in motion by about 0.5mm, so using BRP specs results in ZERO toe-in on the road, or even creeping into toe-out, which is why the steering is often so twitchy on less-than-perfect roads. For RS/GS]
Are there any problems with the can Am Spyder RT?
Below is a list of complaints & problems filed against the 2011 CAN-AM SPYDER RT. These problems includes information received by NHTSA from consumers either directly or as recorded by the Vehicle Safety Hotline. This information may be used by NHTSA during the investigation process.
What kind of audio system does a 2011 Spyder have?
2011 Can-Am® Spyder® RT Audio & Convenience SE5, 2011 Can-AM® Spyder® RT Audio & Convenience SE5 With a fully integrated audio system and a host o… 2011 Can-Am® Spyder® RT-S SE5, SWEET PIECE!!!
Where is the starter wire on a can Am Spyder?
On the solenoid, you have the one red wire that we just mentioned came from the positive terminal of the battery. It goes on the stud with the long nut and is the only wire on that stud. You have another red wire on the solenoid, directly opposite from that one that goes to your starter motor.
What are the models of the Spyder RT?
Models Covered: Spyder RT SM5, Spyder RT SE5, Spyder RTS SM5, Spyder RTS SE5, Spyder RT Audio & Convenience SM5, Spyder RT Audio & Convenience SE5