How do you adjust the sliding door on a Toyota Sienna?
Adjust the position the front lock striker by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer. Tighten the striker mounting screws after the adjustment. Adjust the position of the down stopper by moving the male stopper, so that the male stopper can enter smoothly.
How do I reset the sliding doors on a 2016 Toyota Sienna?
To start resetting Your doors press the door control button on the dash so the red light is on then close the sliding doors. Next You will need to disconnect the negative battery cable and leave it disconnected for at least five minutes.
Does Toyota have a lot of recalls?
Recalls across multiple brands In 2020, Toyota had another major recall. CNN reported that in January, it was 700,000 vehicles. By March, the total was 1.8 million. This included many vehicles such as 2013-2014 Lexus GS 350, 2014-2015 4Runner, Land Cruiser; Lexus GX 460, IS 350, LX 570.
How do you replace a sliding door cable?
Remove the nut holding the cable in the bracket and then slide the cable assembly out of the bracket. Inside the door, there are three bolts holding the cable assembly in place (where the cable makes a right angle turn). Remove all three bolts. Under the arm that connects the door to the van body are two more bolts. Remove them both.
How do you replace a sliding door cable on a Toyota Sienna?
Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place.
How do you replace a sliding door cable on a Honda Odyssey?
Attach the door at this point if you want. Back inside, roll the cables around the pulley as much as you can and push it into the housing. The gear the pulley sits on moves quite freely, so you will have a hard time lining it up right. Clip in the white stoppers, and push the springs into place.
What’s the length of the sliding door cable?
The length of the cable is very important to get right. You don’t have much leeway. For the driver’s side, the cable going toward the front of the van is about 66”. The cable going around the back is about 62”. I did not replace the passenger side, so I can’t tell you those lengths.
How to replace power sliding door cables on 2004-2010?
[I] have a 2004 XLE… driver side cable-spool finally jammed/broke as they all do. At that time, followed your instructions, but bought the cable only repair part for around $200. I wound the spool successfully, and it’s not that hard to.
Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place.
Why did my power sliding door cable snap?
The plastic cable coating failed, and ultimately cross tangled on the spool leading to the cable snapping. No warning, just “bang”, dead. I believe the root cause is one of two things or both: 1) The replacement cable was of insufficient quality, 2) and/or the spool was compressed or compromised during the initial failure.
Why is my Toyota Sienna power sliding door not working?
You are probably here because you opened your 2004-2010 Toyota Sienna’s power sliding door and heard a pop and some crunching noise inside the door and now the door will not automatically open. You’ve come to the right place. Don’t throw $1,000+ down the drain at a dealership–fix this yourself!