How do you adjust the clutch on a Yamaha V-Star 650?
Adjusting the Clutch Cable – Lower End
- Loosen the adjustment at the clutch lever.
- Remove:
- Loosen the locknut.
- Turn the adjusting screw in until it is lightly seated – Be careful, the screw will keep turning with enough pressure.
- Turn the adjusting screw out 1/4 of a turn.
- Hold the adjusting screw in place, tighten locknut.
Where are the adjusters on a V-Star 650?
There are four of these, one over each valve. Remove the valve rocker covers to gain access to the valve stems and adjusters. The one shown here is on the front of the engine. The front and rear most adjusters are the hardest of the 4 to get too.
What are the valves on a Yamaha Road Star?
Yamaha’s newest Road Star 1602cc V-Twin incorporates hydraulic pushrods that reside in chrome tubes on the outside of the cylinder fins. Each pushrod operates rocker arms for intake and exhaust valves at each cylinder, and each rocker arm has a threaded adjuster that permits adjustment.
How do you adjust the valves on a road star?
Grasp tank and gently pull backwards with a slight wiggling motion, tank should slide back a few inches and lift up. Set aside on a towel. Remove two hoses on top of rear cylinder and fold back out of way. Remove spark plug wires from plugs and tie back. Removes possibility of dropping a bolt in an open hole.
Is the Yamaha V Star 650 in production?
For the current model year, the 650 is not in production, but Yamaha does have a 2020 and 2021 VStar 250 available. Yamaha also offers Star touring bikes, but again not in the 650. With so many model years there are plenty of used bikes to search through, although availability is dependent on the local market.
Yamaha’s newest Road Star 1602cc V-Twin incorporates hydraulic pushrods that reside in chrome tubes on the outside of the cylinder fins. Each pushrod operates rocker arms for intake and exhaust valves at each cylinder, and each rocker arm has a threaded adjuster that permits adjustment.
When did the Yamaha V Star 650 come out?
The V Star 650 was produced for many model years from 1998 to present, however not all model years were available in the United States. For the current model year, the 650 is not in production, but Yamaha does have a 2020 and 2021 VStar 250 available. Yamaha also offers Star touring bikes, but again not in the 650.
What kind of oil do I need for a Yamaha V Star 650?
You need SAE80 API “GL-4” hypoid gear oil such as Lucas Oil 80W-90. Tighten the bolt to 23 Nm / 17 lb-ft. Below is the maintenance schedule for the Yamaha V Star 650 (a.k.a. the XVS650) range of motorcycles. From 24000 mi (37000 km) or 36 months, repeat the maintenance intervals in the patterm shown.
How do you adjust the gas tank on a Yamaha Road Star?
Pull the line of the petcock. Pull the vent tube off the top of the gas tank by hand. Remove the metric bolts that hold the rider’s seat to the frame of the motorcycle using a socket and ratchet. Remove the seat. Remove the metric bolt and nut that hold the rear of the gas tank to the frame.