How do you adjust the clutch on a Raptor 350?

How do you adjust the clutch on a Raptor 350?

1. Loosen the locknut at the clutch lever.
2. To increase the clutch lever free play, turn the.
3. Tighten the locknut at the clutch lever.
4. Loosen the locknut at the clutch lever.
5. Fully turn the adjusting bolt at the clutch lever.
6. Loosen the locknut at the crankcase.
7. To increase the clutch lever free play, turn the.

Does a 350 Raptor have a clutch?

The clutch used by your Yamaha Raptor 350 operates through friction generated by a spring-loaded stack of steel and fiber plates. When the clutch is engaged, these plates are pushed against a housing mounted on the end of the engine’s crankshaft. This transfers the engine’s power output to the transmission.

What type of oil does a Raptor 350 take?

Oil Change Kit With Motul Quad 4T 10W-40 for Yamaha RAPTOR 350 2004-2013 – Walmart.com – Walmart.com.

How do I know if my ATV clutch is bad?

Signs of an abused clutch are 1) Shifting under power is difficult and neutral is hard to find. 2) The machine still moves forward with the lever pulled in. 3) In gear, the engine revs high and the vehicle barely moves. 4) A putrid burning smell seeps from the engine.

How do you set a clutch?

Part 1 of 3: Measure Clutch Pedal Freeplay

1. Materials Needed.
2. Step 1: Measure the clutch position.
3. Step 2: Press the clutch and measure its position.
4. Step 3: Determine clutch pedal freeplay.
5. Step 1: Locate the clutch lever and the adjustment locations on the clutch cable.
6. Step 2: Adjust the clutch lever.

What to do if your Raptor 350 clutch slips?

Loosen the clutch cable and see if the slipping occurs again, before attempting to replace the clutch. Do not ride your Raptor 350, if you suspect that the clutch is slipping. A slipping clutch is unreliable and can cause a loss of control, if the clutch slips then grips suddenly.

What happens when the clutch is engaged on a raptor?

When the clutch is engaged, these plates are pushed against a housing mounted on the end of the engine’s crankshaft. This transfers the engine’s power output to the transmission. When the clutch plates wear, they begin to slip against each other, causing a delay in power that affects the performance and safety of your Raptor.

Where is the oil filler cap on a raptor 350?

Park your Raptor 350 on a flat, level work area. Remove the seat and unscrew the oil tank filler cap, located between the seat rails. Place a drain pan below the engine, then unscrew the drain plug from the bottom of the crankcase, using a 21 mm socket and a socket wrench.

What to do when your AC clutch won’t engage?

If your A/C compressor clutch won’t engage because the refrigerant is too low, then you can jump the 30 and 87 pins to get the Clutch Engage. Make sure you are prepared to immediately fill the refrigerant, or shut off the engine and prepare after seeing this works to engage the AC clutch.