How do I use WOL in CMD?
Open the Command Prompt on the computer from which you will be sending the wake-on-LAN command. Type “ping” followed by the computer that you will be sending the wake-on-LAN command’s IP address. For example, if the IP address is “192.168. 1.1,” type “ping 192.168.
How do I enable Wake-on-LAN Windows 7?
- Click Start > Settings > Control Panel.
- Double-click System.
- Click the Hardware tab and click Device Manager.
- Expand the Network Adapters section.
- Right-click on your adapter and select Properties.
- Click the Advanced tab.
- Select Wake-on-LAN Options and click Properties. Set the following: Enable PME: set to Enabled.
What is the Wake-on-LAN command?
As a reminder, the Wake On LAN function enables remote stations to be woken up by sending a “Magic” packet over the network. For this packet to be correctly formed, you need to indicate the MAC address of the network card on the remote computer, along with its broadcast address.
How do I use wolow Wake on LAN?
Open the start menu and type “Device Manager” and open the device manager. Expand “Network Adapters” and right-click your network adapter (typically Intel) and select Properties. Click the “Power” or “Power Management” tab and make sure WOL is enabled. Click OK to save.
What port is WOL?
Wake-on-LAN uses UDP port 9 by default, to send WOL messages. This port is available for use on most Windows computers. However, if you have installed “Simple TCPIP services”, then Windows may be running the “discard” service.
Can RDP wake up computer?
Remote Desktop does not have any built-in remote wake-up capability. You will need to first use Wake-On-Lan to wake up the sleeping computer, before you can RDP to it. To enable WOL on your computer, the first step is to check the hardware : Your network card must support Wake-on-LAN.