How do I turn off the engine maintenance light?
Turn the vehicle off. Press and hold the odometer/trip display button while turning the ignition switch to ON, or pressing the push start button once. Remember: never use the brakes or fully turn the car on! Keep holding the button down until the maintenance required light turns off.
How do you reset the maintenance light on a Toyota Tacoma 2021?
Step by Step Work Guide for How to Turn off Maintenance Light on Toyota Tacoma
- Turning on the Toyota Tacoma.
- Turn off the car and press the reset button of the trio meter.
- Turn off your car’s engine and press the reset button of the trio meter.
- Pressing the reset button.
- Release the reset button.
How do you reset the Check Engine light on a Toyota?
Follow these steps to reset the Toyota check engine light. Park vehicle and set the emergency brakes. Locate the OBD-II port under the dashboard and plug in your scanner. Turn on the ignition but don’t start the engine.
When to turn off maintenance light on Toyota?
When you change the oil or have the vehicle serviced, you will need to turn off maintenance light Toyota so that it can again start counting for 5,000 miles. Toyota recommends not to ignore the light and doing a series of inspections to prevent damages to the engine.
How to reset maintenance light on Toyota RAV4?
Push and hold the trip meter reset button on the dashboard. Turn your key to position two. Hold the odometer button for ten seconds. Your RAV4’s light should flash, perhaps beep, and then go out. Once the light goes out, release the odometer button and start the car.
How do you reset maintenance light Toyota Camry?
Follow these few simple steps to reset maintenance light Toyota that is not a Camry or Prius: Put the ignition key into the slot and turn on the car without kicking off the engine. The odometer should read ‘Trip A’. If it does not, press down the ‘Reset’ or ‘Trip’ button until the reading on the odometer displays ‘Trip A’.