Menu

Navigation

How do I turn off SRS?

Posted on by Arif Clayton

How do I turn off SRS?

How to Disable Airbag System? Find out here!

  1. Purge the Power. The first step involved in the process of how to disable airbag system in your car is to cut off the power.
  2. Take Out the Fuse.
  3. Take Away the Dashboard Cover.
  4. Immobilize the Passenger Airbag.
  5. Remove the Steering Wheel’s Lower Panel.
  6. Finally, Disable the Airbag.

Will removing airbag fuse?

The dust that comes out of the airbags won’t hurt you, but you don’t want it all over you or in your eyes, either. Simply pulling the airbag fuse may not disable the airbags. Many ACMs utilize an internal battery to ensure deployment even if the power is cut.

How can I reset the SRS light or fix it?

There are two ways to reset the SRS light: with an SRS scanner and manually. The SRS Light can be reset with an OBD2 Scan Tool. When using an SRS scanner, there are a few steps to follow. Step #1 – Find the fuse-cover and take it off. Step #2 – Fit the scanner in the port. Step #3 – Turn ignition to the “run” spot.

Can the SRS light be reset at home?

You can reset the airbag light on your vehicle from your home garage, saving yourself a trip to the dealership or mechanic. The airbag light, also known as the SRS light (supplemental restraint system), illuminates on the vehicle’s instrument panel usually only after the vehicle has been in an accident and the airbag has deployed.

Why does the SRS light stay on?

If you see the SRS light on, you must work to know why. It can be due to a variety of reasons including: The malfunctioning of airbag sensors: It is common for the sensors to fail. This may cause the sensor to activate all of a sudden for no reason, causing the airbag light to stay on. Replacing the sensors may do the job.

How do you reset airbag light?

Step 1 Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light.