How do I set my Ford EVAP monitor?
Start the engine and idle for four minutes, then drive in stop-and-go traffic for five minutes using smooth accelerations and decelerations. Stop and idle for 4 minutes. The EVAP monitor should be complete.
How do you complete a Ford drive cycle?
Idle the vehicle in Drive for 1 minute. Drive at 25 mph and drive for 15 minutes at speeds between 15-35 mph. Within this time, stop at least 5 times, and have at least 3 periods of steady speed for 90 second durations. Drive the vehicle between 45-60mph for 8 minutes.
How do you force a readiness monitor?
Start the engine and idle the engine in drive for two and half minutes, with the A/C and rear defroster on if equipped. Turn the A/C and rear defroster off, and speed up to 90 km/h (55 mph) under moderate, constant acceleration. Hold at a steady speed for three minutes. Slow down to 30 km/h (20 mph) without braking.
How do you clear a P1000 code?
In order to clear a P1000 trouble code the vehicle must be driven through a Drive Cycle until all monitors are completed or in ready status.
How long do you have to drive to complete a Drive Cycle?
Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving.
How do I reset my car monitor?
Start cold (below 86°F /30°C) and warm up until engine coolant temperature is at least 160° F (typically requires at least one minute; up to 3 minutes). Accelerate to 40-55 MPH at 25% throttle and maintain speed for five minutes. Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle.
How to clear a P1000 Ford engine code?
No scanner it’s necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnose cycle will clear the code. Clearing the code will reset the light unless other codes present. The cost to diagnose the P1000 FORD code is 1.0 hour of labor.
Where is the P1000 code stored in OBD?
P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check. | Need more information with the P1000 FORD code? Need more information on how to fix the P1000 FORD code?
When did the Ford C Max come out?
The Ford C-Max is a compact multi purpose vehicle which was introduced in 2003 by Ford in Germany. Initially it was available only in Europe and partially in New Zealand and is the second smallest MPV from Ford, after the B-Max. In the USA it was released in September 2012 as Ford?s first hybrid-only version, which includes the CMax Hybrid.