How do I reset the service indicator on a Mercedes e500?
Press button (UP arrow) or (DOWN arrow) on the multifunction steering wheel until the FSS indicator appears in the display. Press the reset knob for about 5 seconds until the SERVICE MENU appears in the multifunction display. Select the CONFIRMATION menu with the (plus) or (minus) button.
Where is the shut down button on a Mercedes Benz?
This is located behind your ignition tumbler. Remove the instrument cluster and remove the switch’s connector by wiggling it out very slowly and carefully. Remove the three screws, replace the unit, reinstall the three screws and reinstall the connector.
What happens when Mercedes Benz air suspension stops working?
When they stop working the air suspension control unit may no longer be able to recognize the height of the car. Your Mercedes-Benz will greet you with a warning message on the dash related to the airmatic failure. The car height may be correct and the car still rides fine, it’s just that the computer doesn’t know that.
Why does my car shut down while driving?
The car is automatic (not manual). I’m driving in my car just like a normal person and all of a sudden the RPM starts dropping to zero then going back up to 9 a couple of times afterwards it shuts down. It doesn’t matter what the speed I’m driving at.
What should the fuse look like on Mercedes Benz air suspension?
Procedures are similar for other Mercedes-Benz with air suspension, but the location of the relay and fuse may change. In this S-Class W220, the air compressor motor /pump is protected by Fuse 32, which is a MaxiFuse 40 Amp. Here is what a good fuse should look like.
This is located behind your ignition tumbler. Remove the instrument cluster and remove the switch’s connector by wiggling it out very slowly and carefully. Remove the three screws, replace the unit, reinstall the three screws and reinstall the connector.
When does the COMAND system shut down Mercedes Benz?
I persisted with MB technical support; here is how they replied: The E350 has an on-board system which continuously monitors voltage. The Comand system is apparently one of the largest electrical loads on the vehicle. When the level goes beyond a certain threshold, Comand is intructed to shut down.
What should I do if my Mercedes Benz won’t start?
Start the car and you should be able to get around 60 psi. When the engine is running and when you turn off the engine the pressure should stay steady. Always perform this test on a cold engine. Next, make sure that the fuel injector connections are secure and not loose. Check the fuel pump and the fuel pump relay.
What are the problems with a Mercedes Benz?
Top 5 Mercedes-Benz no start problems 1 Engine Click, No Start 2 Engine Dies Right After It Starts 3 Car turns over, but it won’t start 4 The car makes a clicking noise but won’t start. Hint: Starter Problem or Low Battery 5 Key will not turn the ignition More