How do I reset the airbag light in my car?
Turn the switch off. Test again by repeating the above steps two more times. Start the car’s engine. The airbag light should turn on for a few seconds, shut off, and remain off until the next time the car’s engine is turned on again. The car’s airbag light has been reset.
How to read and reset SRS / airbag light?
Battery dying. How to read and reset SRS/ Airbag light? Very often the SRS/Airbag light goes on mainly because of a dying battery. But, if the light is on, it will stay on when you install a new battery, until you manually reset it. That is, 2 steps to solve SRS/Airbag light on. Reset SRS/ Airbag light. 1. Locate the fuse panel cover and remove it.
What should I do if my airbag sensor goes out?
You will need to wait for at least five seconds to pass. Once it has, you are ready to reconnect the negative terminal. Make sure that the sensor reset by turning on the key switch in your vehicle. If the airbag sensor warning light has gone out, it has been reset. If you find that the light has not gone out, repeat the previous steps.
Why does the airbag light come on after battery change?
Strange thing happened this morning – the Airbag Light came on, after changing the car battery. It has never come on before. What caused this? The light might have came on before you disconnected the bad battery due to low voltage to the system.
How do you reset the passenger airbag light?
Put the key into the ignition and turn the switch to the “on” position. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
Why does the airbag light stay on?
Light stays on and warning for airbag service on reader board. If the airbag light stays on after it completes it’s “check light” process then there is a fault in the air bag system. It could be anything from a bad sensor (there are 3 of them) to a wire that has become unplugged. This problem should be repaired as soon as possible because…
How are airbags fixed after an accident?
After an accident occurs, airbags are fixed by resetting the sensors and replacing the airbag unit. Most modern vehicles will not allow you to reset an airbag for safety precautions, and instead, you must replace it entirely. This requires removing the old airbag from the driver or passenger side and installing a new one.
What does it mean when the airbag light is flashing?
A flashing airbag warning light indicates a significant problem with the SRS system meaning you should take it to a repairer immediately. If the light stays on, you should still take it to repairer, however, there are a few things you can try first that could rectify the problem.