How do I know my main bearing size?
The commonly accepted rule that most crankshaft manufacturers prefer for street and performance engines is 0.0010-inch for every 1-inch of journal diameter. So for a 2.45-inch small-block main journal, the bearing clearance would be 0.0024-inch.
How do I choose bearing clearance?
For these reasons, bearing clearances are specified as “vertical clearance” and must be measured at 90 degrees to the split line. The best method of measurement is with a dial bore gage that measures the bearing inside iameter when the bearings are installed at the specified torque without the shaft in place.
What does C3 stand for on a bearing?
Internal clearance
Internal clearance being C3 means that the bearing has room for expansion if needed between the races of the bearing, whilst holding the outer ring and moving the inner ring in a radial movement you will detect a little amount of play between the two rings.
How important are torque specs?
Proper torque is critical for two reasons. First, it secures the axle nut so it won’t work itself loose and back off. Second, the proper torque keeps the correct load on a hub assembly needed for longer bearing life. Torque specifications can be different, even for the same hub, if it’s multiple applications.
What are the main bearings in an engine?
In a piston engine, the main bearings are the bearings which hold the crankshaft in place and allow it to rotate within the engine block . Main bearings are usually plain bearings or journal bearings, held in place by the engine block and bearing caps.
What are the torque specifications?
Torque is part of the basic specification of an engine: the power output of an engine is expressed as its torque multiplied by its rotational speed. Internal-combustion engines produce useful torque only over a limited range of rotational speeds (typically from around 1,000–6,000 rpm for a small car).
What is the head bolt torque specs?
Torque specs: Torque specs: CYLINDER HEAD BOLT TORQUE SPECS (tightening) / (loosening) 8, 4, 2, 6, 10 7, 3, 1, 5, 9. Torque in steps: 22ft-lbs (264in-lbs), Then to 63ft-lbs (756in-lbs) (final spec) 94+ Teg