How do I get my Jeep key unstuck?
With the engine off, shifter in park, your foot on the break, quickly press and release the shifter button a few times. Do this without shifting. This will temporally dislodge the solenoid cap and allow you turn the ignition to the natural position where the key can be removed. Repeat as necessary.
Is there a problem with the ignition on a Jeep Cherokee?
If there is one common denominator amongst practically all 1984 to 1996 Jeep Cherokees (XJ , ZJ, WJ and WK’s alike) it is a bad ignition. Though typically robust, most Jeep Cherokees will eventually experience ignition failure, leaving otherwise happy owners stranded.
Why does my Jeep Cherokee not turn on?
Symptoms don’t get more straightforward than this: The truck doesn’t start. Turn the key, and everything comes on, but the driveway is absent of that Jeep rumble. When you turn the key, a number of things happen. First, the key-switch engages the vehicle’s accessory systems like the radio.
What happens when your key won’t turn in?
If your key won’t turn your ignition lock cylinder and the steps above did not get your ignition to turn, then there is an extremely good chance your vehicle is in the list below. The list below is just a partial list of vehicles we suspect of having ignition failure problems when people call and say “My key won’t turn in my ignition”.
What happens when there is no power in a jeep?
If there is no power, then the electrical circuit supplying the motor has a fault. That circuit begins at the battery and includes grounds, wiring (some of which is very heavy cabling), fuses, relays, the ignition switch and terminations.
Can a bad ignition switch keep a Jeep Cherokee from starting?
A bad ignition switch can cause your Cherokee not to start at all. And, it can keep your Cherokee from starting in a couple of different ways. The first is when the starter cranks, but the bad ignition switch doesn’t turn on the fuel pump or ignition.
What does it mean when your key is stuck in ignition?
Key Stuck In Ignition Fixed! Per my post, dated 01-05-2012, 09:36 PM. I found and fixed the key and start problems. Back in January I was experiencing a problem where I wasn’t able to turn the key to the natural position where the key can be removed from the ignition. This was due to the binding of parts within the shift mechanism.
How do you get the ignition key out of a jeep?
Access the solenoid: Lift the rubber mat off the tray and remove the two tray screws. You will see the solenoid. It’s a white cylinder with a metal bar protruding rearward toward the shifter. You might opt to remove the center console too. Quick Fix: If you’re in a jam and need to remove the key without disassembling things read on.
What are the symptoms of a bad ignition switch?
The most noticeable symptom of a bad ignition switch is stalling. Your Cherokee stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2. Starts then Dies