How do I fix the error code on my electric bike?
Bypassing the motor cable, plug connection with the controller into the motor. If error code remains, test with new motor core and controller error. Unplug brake pads, and to check each brake, restart the bike. If the error remains, try a new controller after unplugging the brakes.
How do I reset my Shimano battery?
Try a battery reset. Fully charge battery, remove it from bike, press and hold power button until all the lights go out then put it back on the bike and on charge.
Why is my crankshaft sensor still showing the same code?
Still showing original code saying to replace crankshaft sensor. the code for crank sensor does not mean the sensor needs to be replaced. it means the ecm does not recognise the signal, the signal is not there or it is erratic. thats why you pay for a real diag instead of a free diag from a parts person who has never fixed a car.
What to do if you get an error code on your Harley Davidson?
Turn OFF the ignition switch. Run your bike and shut it down then recheck the DTCs again by repeating steps 1 to 9. If the code is current it will reappear. Press and release the odometer reset button to continue to the next module. Turn Ignition switch to OFF.
What happens when crankshaft position sensor ( CKP ) fails?
If the sensor (CKP) has failed completely, then the computer won’t send any fuel to the injectors. Consequently, Leaving you unable to start the car. A Crankshaft Position Sensor (CKP) Failure may cause the check engine light on your dashboard to come on.
What does the Code 02 mean on a Harley Davidson?
If it were a current code, the light would remain lit while running. Above codes can also be set if 02 sensor fails. CKP – Crank Position Sensor. The CKP generates an “AC signal” which is sent to the ECM where it is used to reference engine position (TDC) and speed.
Still showing original code saying to replace crankshaft sensor. the code for crank sensor does not mean the sensor needs to be replaced. it means the ecm does not recognise the signal, the signal is not there or it is erratic. thats why you pay for a real diag instead of a free diag from a parts person who has never fixed a car.
What does ECU code C12 mean when bike wont start?
When the bike will not start the ECU code read c12 “crank positioning sensor fault or Trigger Coil sensor”. Fuel injected models have the crank positioning sensor and carbureted models have the trigger coil. I found a loose connection that was causing the intermittent errors and not letting it start. I repaired it and everything seems good.
Turn OFF the ignition switch. Run your bike and shut it down then recheck the DTCs again by repeating steps 1 to 9. If the code is current it will reappear. Press and release the odometer reset button to continue to the next module. Turn Ignition switch to OFF.
If it were a current code, the light would remain lit while running. Above codes can also be set if 02 sensor fails. CKP – Crank Position Sensor. The CKP generates an “AC signal” which is sent to the ECM where it is used to reference engine position (TDC) and speed.