How do I fix my Honda Accord radiator?
- Step 1 – Lift and support vehicle. You will need to access lines and fittings at the bottom of the radiator.
- Step 2 – Drain the coolant.
- Step 3 – Remove electrical fans.
- Step 4 – Disconnect lines and hoses.
- Step 5 – Unbolt and remove radiator.
- Step 6 – Clean up and install new radiator.
- Step 7 – Bleed coolant system.
How do you replace the radiator on a Honda Accord?
Keep your drain bucket under the lower radiator hose. Use hose clamps to pinch the transmission lines shut. This helps to reduce the amount of transmission fluid you will lose and also makes cleanup easier. Also, be sure the release the transmission cooler line retaining bracket from the radiator so that it doesn’t get hung up.
What to do if your plastic radiator has a crack?
Mark the cracked area with a marker or tape. Then wait for the tank to cool down and take the cap off. Check if the crack is above or below the coolant level. If it is situated below, you have to drain some coolant until the crack shows up above the coolant level.
Can a broken hose connection on a plastic radiator be repaired?
Hose connections on plastic radiators can crack and break, causing coolant to leak, which can expose the engine to potential overheating unless repaired swiftly. Fortunately, another upside to plastic radiators is that they are relatively easier to fix than traditional brass radiators.
How do you repair a broken radiator welding rod?
Once the rod has begun to melt, place it on one side of the hose connector. Press the two broken surfaces together and hold for several minutes while the welding rod cools. Allow the plastic welding to set before reinstalling the radiator.
Keep your drain bucket under the lower radiator hose. Use hose clamps to pinch the transmission lines shut. This helps to reduce the amount of transmission fluid you will lose and also makes cleanup easier. Also, be sure the release the transmission cooler line retaining bracket from the radiator so that it doesn’t get hung up.
Where is the coolant drain on a Honda Accord?
Place your coolant drain bucket underneath, and open the drain valve located on the bottom of the radiator. Figure 2. Find the drain plug and remove it. Work on your car while it is cold. Hot coolant can burn you, and many of the parts you will be accessing are right near the exhaust manifold.
Where is the drain valve on a radiator?
Remove the radiator cap, and set it to the side. Place your coolant drain bucket underneath, and open the drain valve located on the bottom of the radiator. Figure 2. Find the drain plug and remove it. Work on your car while it is cold. Hot coolant can burn you, and many of the parts you will be accessing are right near the exhaust manifold.