How do I find the code for my Jeep Compass?
The only way to know why your Check Engine Light is on is to plug a scan tool into your vehicle’s OBD II diagnostic connector. The scan tool will then display the trouble code or codes that have been set. Most scan tools will display the trouble code and a one line description or definition of the code.
Where is the OBD2 port on a Jeep Compass?
OBD2 port Jeep Compass (2006 – 2016) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
Where to find check engine light codes on Jeep?
These are listed in numerical order for easy searching. When retrieving Jeep check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
What does OBD stand for in a jeep?
Jeep OBDII Readers OBD2 Code Tool Scanner. A jeep is a small, blocky, military style vehicle that is four wheeled and able to move on a rough terrain. OBD is On Board Diagnostics that is used in electronic monitoring of engine controls and other specific parts of the vehicle like the body and chassis.
Where is the OBD located on a car?
The connector must always be located within three feet of the driver. The OBD is also essential because it allows you to read the information from the car using a plug-in diagnostic tool that enables you to read fault codes or error codes. You therefore need to know what the codes mean depending with what is contained in the manufacturer’s manual.
OBD2 port Jeep Compass (2006 – 2016) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.
These are listed in numerical order for easy searching. When retrieving Jeep check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
Where can I find the OBD code for my Acura?
If there is no procedure for your manufacturer specific code, then I suggest referring to a similar generic OBD II code (these are listed numerically by system type) to get a good idea of what to look for. If at this point you still need assistance use the “Get Help” link and let us know how we can help.
What do you need to know about the Cherokee compass?
Signal wire open/short circuit, valve body, sensor supply wire open circuit, transmission fluid level, governor pressure solenoid, transmission mechanical fault, ECM -no 5 volt supply Signal wire short circuit to ground/positive, supply wire open/short circuit, transmission fluid level, governor pressure solenoid, governor pressure sensor, ECM