How do I create a VLAN on an HP switch?

How do I create a VLAN on an HP switch?

Configuring basic VLAN settings

  1. Enter system view, use the command: system view.
  2. Create VLANs, use the command: vlan { vlan-id1 [ to vlan-id2 ] | all }
  3. Enter VLAN view, use the command: vlan vlan-id.
  4. Configure a name for the VLAN, use the command: name text.
  5. Configure the description of the VLAN, use the command:

Can a switch port have multiple VLANs?

You can have three vlans on one port if the switch configuration allows it. Mine allows one for data and one for VoIP. The quick answer is yes, That’s called a trunk. Your specific hardware will determine what is possible.

Does my switch support VLAN?

No, not all switches support VLAN tagging. Also, not all switches that support VLANs support tagging. Some VLANs are port based – you can group ports on the switch as a VLAN, but the packets are not tagged.

How many different VLANs are possible on a single Ethernet port?

Under IEEE 802.1Q, the maximum number of VLANs on a given Ethernet network is 4,094 (4,096 values provided by the 12-bit VID field minus reserved values at each end of the range, 0 and 4,095).

How do you see what VLAN I am on?

How to Check What VLAN You’re On

  1. Connect to your VLAN using your Ethernet cable. Video of the Day.
  2. Open your packet analyzer program. Select the network card to listen to; you’ll want to select the one connected to your VLAN.
  3. Scan the incoming packets to your computer; these are the ones that are going to be labeled.

What is a VLAN port?

A VLAN is a set of end stations and the switch ports that connect them. A given port can handle traffic for more than one VLAN, but it can support only one default VLAN ID. The Private Edge VLAN feature lets you set protection between ports located on the switch.

How do VLANs work on a switch?

Virtual Local Area Networks (VLANs) separate an existing physical network into multiple logical networks. Thus, each VLAN creates its own broadcast domain. Communication between two VLANs can only occur through a router that is connected to both. VLANs work as though they are created using independent switches.

What is the native VLAN of a hp switch?

On the HP switch, port 20 is untag vlan 8. vlan1 is not used on the HP side. So i’m assuming the native vlan of that port is 8. On the router side, the link is considered an edge port(not configured as trunk) and its pvid is 69.

How many VLANs can a network switch support?

In the factory default state, the switch is enabled for up to 256 VLANs, all ports belong to the default primary VLAN and are in the same broadcast/multicast domain. You can reconfigure the switch to support up to 2048 VLANs, with up to 4094 VIDs,by adding new VLAN names and VIDs and then assigning one or more ports to each VLAN.

What’s the difference between a trunk and access port on a hp switch?

HP switches don’t make a distinction between a “trunk” port and an “access” port. It’s all the same. Any port can carry any vlan’s tagged traffic and the untagged traffic for a single vlan. The distinction is whether a specific port is carrying tagged or untagged traffic for a particular VLAN.

Is the HP device port on VLAN 69 or 69?

Assume that the HP device port is untagged on VLAN 8 and tagged on VLAN 69; Cisco port access VLAN is 69 and VLAN 8 is trunked. The traffic will pass on both VLANs, but you have a PVID mismatch.